DISASSEMBLY
Removal / installation · Vehicles built Jan 2015 – Dec 2016
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Dec 2016 from Jan 2017
- NOTICE:
- Do not try to remove the nylon tube as it is welded to the fuel suction with pump and gauge tube assembly (Click here).
| 1.
REMOVE FUEL SENDER GAUGE ASSEMBLY |
 |
- Disconnect the fuel pump harness connector and fuel sender gauge connector.
- Press down on the fuel sender gauge claw labeled A. Then slide the fuel sender gauge assembly upward to remove it.
Text in Illustration
 
|
Press down
|
 
|
Slide
|
| 2.
REMOVE NO. 1 FUEL SUB-TANK |
 |
- Disconnect the jet pump from the No. 1 fuel sub-tank.
Text in Illustration
*1
|
Jet Pump
|
Detach the claw and 2 clamps from the No. 1 fuel sub-tank.
- NOTICE:
- Do not damage the No. 1 fuel sub-tank.
- Using a screwdriver with its tip wrapped in protective tape, detach the 5 claws to remove the No. 1 fuel sub-tank.
- NOTICE:
- Do not damage the No. 1 fuel sub-tank.
| 3.
REMOVE FUEL PUMP |
 |
- Using a screwdriver with its tip wrapped in protective tape, detach the 5 claws to remove the fuel pump from the fuel filter assembly.
- NOTICE:
- Do not damage the fuel filter assembly.
Disconnect the fuel pump harness connector from the fuel pump.
Remove the O-ring from the fuel filter assembly.
Remove the fuel pump spacer from the fuel pump.