2014-2019 Hiace · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Oct 2014


1. INSTALL EXHAUST PIPE ASSEMBLY TAIL
  1. Connect the exhaust pipe assembly tail to the exhaust pipe supports.


2. INSTALL EXHAUST PIPE ASSEMBLY FRONT
  1. w/ Secondary air injection system:

    1. Install the fuel ratio sensor. (Click here)

      Torque:
      44 N*m{ 449 kgf*cm , 32 ft.*lbf }

  1. For unleaded gasoline engine:

    1. Install the oxygen sensor. (Click here)

      Torque:
      44 N*m{ 449 kgf*cm , 32 ft.*lbf }

  1. Inspect the compression spring.

    1. A077857
      Using vernier calipers, measure the free length of the compression springs.

      Minimum length:
      40.5mm(1.594 in.)

      HINT:
      If the free length is less than the minimum, replace the compression spring.

  1. A102062E03
    Install the gasket.

    1. Fully insert a new gasket to the exhaust manifold by hand.

    2. Using a wooden block, uniformly strike the gasket so that the gasket and exhaust manifold are properly fit.

      NOTICE:
      1. Be careful with the installation direction of the gasket.
      2. Do not reuse the gasket.
      3. Do not damage the gasket.
      4. To ensure a proper seal, do not use the exhaust pipe assembly front to force the gasket onto the exhaust manifold.

  1. Install a new gasket to the exhaust pipe assembly front.

  1. Connect the exhaust pipe assembly front to the exhaust pipe support.

  1. Install the exhaust pipe assembly front with the 4 bolts, 2 nuts, and 2 compression springs.

    Torque:
    Exhaust manifold side:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }

    Torque:
    Exhaust pipe assembly tail side:
    48 N*m{ 489 kgf*cm , 35 ft.*lbf }

    NOTICE:
    After installation, check that the clearance is almost the same at any point between the flanges of the exhaust manifold and exhaust pipe assembly front.

  1. For unleaded gasoline engine:

    1. Connect the sensor connector(s).


3. CHECK EXHAUST GAS LEAKS
← REMOVAL (from Oct 2014)COMPONENTS (from Oct 2014) →