REMOVAL
Removal / installation · Vehicles built from Oct 2014
| 1. DISCONNECT NEGATIVE BATTERY CABLE |
| 2. REMOVE ENGINE UNDER COVER NO.1 (w/ Engine Under Cover No.1) |
| 3. REMOVE FRONT DOOR SCUFF PLATE RH |
| 4. REMOVE FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type) |
- HINT:
- Perform the same procedure as above on the opposite side. (Click here)
| 5. REMOVE FRONT SEAT ASSEMBLY RH (for Low-back Seat Type) |
- HINT:
- Perform the same procedure as above on the opposite side. (Click here)
| 6. REMOVE ENGINE SERVICE HOLE SUB COVER ASSEMBLY |
Roll up the carpet, and remove the engine service hole sub cover assembly.
| 7. REMOVE FENDER APRON MUDGUARD SEAL RH |
| 8. REMOVE FAN & GENERATOR V BELT |
Remove the drive belt by rotating the tensioner pulley in clockwise direction to loosen its tension with the pulley set bolt of the tensioner.

| 9. SEPARATE COMPRESSOR AND MAGNETIC CLUTCH (w/ Air Conditioning System) |
Disconnect the connector.
Remove the 4 bolts and compressor and magnetic clutch.

| 10. REMOVE AIR TUBE ASSEMBLY |
Remove the 2 clamps, 2 bolts and air tube assembly.
| 11. REMOVE AIR CLEANER HOSE ASSEMBLY |
Remove the bolt and air cleaner hose assembly.
| 12. REMOVE VENTILATION PIPE |
Remove the bolt and ventilation pipe.
| 13. REMOVE COMPRESSOR OUTLET ELBOW |
Remove the 2 bolts and 2 clamps, then remove the compressor outlet elbow.

| 14. REMOVE IDLE NO.2 PULLEY ASSEMBLY (w/ Air Conditioning System) |
Remove the bolt and washer, then remove the idle No.2 pulley assembly.

| 15. REMOVE GENERATOR BRACKET |
Remove the 2 bolts, then remove the generator bracket.

| 16. REMOVE GENERATOR ASSEMBLY |
Disconnect the generator connector.

Remove the terminal cap.
Remove the nut and disconnect the wire harness from terminal B.
Remove the bolt and generator assembly.
