2014-2019 Hiace · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Oct 2014


1. DISCONNECT NEGATIVE BATTERY CABLE

2. REMOVE ENGINE UNDER COVER NO.1 (w/ Engine Under Cover No.1)

3. REMOVE FRONT DOOR SCUFF PLATE RH

4. REMOVE FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type)

HINT:
Use the same procedures described for the LH side. (Click here)


5. REMOVE FRONT SEAT ASSEMBLY RH (for Low-back Seat Type)

HINT:
Use the same procedures described for the LH side. (Click here)


6. REMOVE ENGINE SERVICE HOLE SUB COVER ASSEMBLY
  1. Roll up the carpet, and remove the 5 bolts and engine service hole sub cover.


7. REMOVE FAN & GENERATOR V BELT

  1. A102135E01
    Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and decrease the tension in the drive belt. Then remove the drive belt.

    NOTICE:
    When removing the drive belt, do not use the idle pulley's bolt.

    HINT:
    After removing the drive belt, move the tensioner upward to the maximum amount.


8. REMOVE GENERATOR ASSEMBLY

  1. A088507
    Disconnect the generator connector.

  1. Remove the terminal cap.

  1. Remove the nut and disconnect the wire harness from terminal B.

  1. Remove the 3 bolts and generator assembly.

← COMPONENTS (from Oct 2014)DISASSEMBLY (from Oct 2014) →