2014-2019 Hiace · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Jan 2017


1. REMOVE PROPELLER SHAFT ASSEMBLY

  1. C102185E01
    Put matchmarks on both flanges.

  1. Remove the 4 nuts, bolts and washers.

    HINT:
    If the flange connection is hard to separate, temporarily tighten one nut only and evenly tap the flange with a brass bar and hammer to separate the propeller shaft assembly from the differential companion flange.

  1. Remove the propeller shaft assembly.

  1. C102186E01
    Insert SST in the transmission to prevent oil leakage.

    NOTICE:
    Do not damage the oil seal.


    1. Use the following SST for the automatic transmission

      SST
      09325-40010  

    2. Use the following SST for the manual transmission

      SST
      09325-20010  


2. DISCONNECT FUEL TANK WIRE

  1. A102471E01
    Disconnect the fuel tank wire.


3. DISCONNECT FUEL TANK RETURN TUBE

  1. A102468E01
    Disconnect the fuel tank return tube (Click here).


4. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY

  1. A102470E01
    Disconnect the fuel tank main tube sub-assembly.


5. DISCONNECT FUEL TANK BREATHER TUBE

  1. A102474E01
    Slide the clip and disconnect the fuel tank breather tube from the fuel tank assembly.


6. REMOVE FUEL HOSE PROTECTOR

  1. A309405
    Detach the 2 claws to remove the fuel hose protector from the fuel tank to filler pipe hose.


7. DISCONNECT NO. 3 FUEL HOSE

  1. A102472E01
    Loosen the clamp bolt and disconnect the No. 3 fuel hose.


8. REMOVE FUEL TANK ASSEMBLY
  1. Remove the bolt and disconnect the No. 3 parking brake cable.

  1. Support the fuel tank with a transmission jack.

  1. A102475E01
    Remove the 6 bolts, 2 fuel tank bands and fuel tank assembly.


9. REMOVE FUEL SENDER GAUGE ASSEMBLY
  1. Remove the fuel tank wire, No. 1 fuel evaporation tube sub-assembly, fuel tank main tube sub- assembly and fuel tank return tube sub-assembly from the fuel sender gauge assembly.

  1. Remove the No. 1 fuel evaporation tube sub-assembly, fuel tank main tube sub-assembly and fuel tank return tube sub-assembly from the fuel hose grommet.

  1. Remove the fuel hose grommet from the fuel tank assembly.

  1. Remove the 8 bolts, fuel pump gauge retainer, fuel suction tube set gasket and fuel sender gauge assembly.

← COMPONENTS (from Jan 2017)INSTALLATION (from Jan 2017) →