INSTALLATION
Removal / installation · Vehicles built from Oct 2014
| 1. INSTALL GLOW PLUG |
- NOTICE:
- Measure the resistance of the glow plug when reinstalling it.
If the result is not as specified, replace it with a new one.
- Replace the glow plug with a new one when it has been dropped or subjected to a physical impact.
- Remove any carbon deposits from the glow plug hole when reinstalling it.
- Measure the resistance of the glow plug when reinstalling it.
Wrap tape around a 4 mm drill, 118.5 mm (4.665 in.) from its tip.

Insert the drill 118.5 mm (4.665 in.) into the glow plug hole and remove the carbon deposits by manually turning the drill.
Insert the 4 mm drill into the glow plug hole and remove any carbon deposits from the tip end portion of the glow plug hole by manually turning the drill.
Install the 4 glow plugs.
- Torque:
- 13 N*m{ 133 kgf*cm , 10 ft.*lbf }
- NOTICE:
- Do not use any tools, such as air tools, which are liable to cause any impact to the glow plugs, when installing them.
| 2. INSTALL NO. 2 INTAKE MANIFOLD INSULATOR |
| 3. INSTALL NO. 1 GLOW PLUG CONNECTOR |
Temporarily install the No. 1 glow plug connector with the 4 nuts.
Tighten the 4 nuts to the specified torque.
- Torque:
- 2.2 N*m{ 22 kgf*cm , 19 in.*lbf }
Install the 4 screw grommets.
Connect the wire harness to the No. 1 glow plug connector and install the nut.
- Torque:
- 2.6 N*m{ 27 kgf*cm , 23 in.*lbf }
Install the screw grommet.
| 4. INSTALL MANIFOLD STAY |
Install the manifold stay with the 2 bolts.
- Torque:
- 19 N*m{ 194 kgf*cm , 14 ft.*lbf }
| 5. INSTALL COMMON RAIL |
