2014-2019 Hiace · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Jan 2017

CAUTION:
Make sure to wear protective gloves when performing work to avoid burns.


1. WARM UP ENGINE

NOTICE:
To protect the glow plug assembly from damage, before removing the glow plug assembly, make sure to warm up the engine.


2. REMOVE COMMON RAIL ASSEMBLY
(Click here)

3. REMOVE NO. 1 GLOW PLUG CONNECTOR

CAUTION:
Make sure to wear protective gloves when performing work to avoid burns.

  1. A398578
    Using an E8 "TORX" socket wrench, remove the stud bolt from the intake manifold.

  1. A398579
    Remove the 4 glow plug screw grommets.

  1. A398580
    Remove the 4 nuts and No. 1 glow plug connector.


4. REMOVE GLOW PLUG ASSEMBLY

CAUTION:
Make sure to wear protective gloves when performing work to avoid burns.

  1. A398581
    Using a 10 mm deep socket wrench, remove the 4 glow plug assemblies.

← ON-VEHICLE INSPECTION (from Jan 2017)INSTALLATION (from Jan 2017) →