2014-2019 Hiace · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jan 2017


CHECK GLOW PLUG ASSEMBLY
  1. Remove the No. 1 glow plug connector (Click here).

  1. A346966
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Glow plug terminal - Body ground
    20°C (68°F)
    Approximately 1.0 Ω

    If the result is not as specified, replace the glow plug assembly.

    NOTICE:
    1. Be careful not to damage the glow plug assemblies, as this may cause an open circuit or shorten the life of the glow plug assemblies.
    2. Do not allow oil or gasoline to contact the glow plug assembly when cleaning it.
    3. Clean off any oil on the terminal with a dry cloth.
    4. Do not apply more than 11 V to the glow plug assembly, as this may cause an open circuit.

  1. Install the No. 1 glow plug connector (Click here).

← COMPONENTS (from Jan 2017)REMOVAL (from Jan 2017) →