INSTALLATION
Removal / installation · Vehicles built Jan 2015 – Mar 2016
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017
- HINT:
- Perform "Inspection After Repairs" after replacing the Air fuel ratio sensor (Click here).
| 1. INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1) |
- HINT:
- Perform "Inspection After Repairs" after replacing the Air fuel ratio sensor (Click here).
Using SST, install the air fuel ratio sensor to the front exhaust pipe assembly.

- SST
- 09224-00010
- Torque:
- without SST:
- 44 N*m{ 449 kgf*cm , 32 ft.*lbf }
- with SST:
- 40 N*m{ 408 kgf*cm , 30 ft.*lbf }
Text in Illustration *a
Fulcrum Length
- HINT:
- Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). If using a torque wrench with a length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (Click here).
- Make sure SST and the wrench are connected in a straight line.
- Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). If using a torque wrench with a length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (Click here).
Connect the air fuel ratio sensor connector.
