2014-2019 Hiace · Service Manual BODY

ADJUSTMENT

Removal / installation · Vehicles built from Oct 2014


1. INSPECT SLIDE DOOR

  1. Check that the clearance of areas A to D are within the standard range.

    B164201E01

    Standard:
    Area
    Measurement
    A
    6.9 +/- 1.5 mm (0.272 +/- 0.059 in.)
    B
    5.5 +/- 1.5 mm (0.217 +/- 0.059 in.)
    C
    5.8 +/- 1.5 mm (0.228 +/- 0.059 in.)
    D
    5.0 +/- 1.5 mm (0.197 +/- 0.059 in.)


2. ADJUST SLIDE DOOR
  1. Disconnect the cable from negative (-) battery terminal.

    CAUTION:
    Work must be started at least 90 seconds after the engine switch is turned off and the negative (-) terminal cable is disconnected from the battery. (The SRS is equipped with a back-up power source. If work is started within 90 seconds of disconnecting the cable from the negative (-) battery terminal and turning the engine switch off, the SRS may deploy.)

  1. Loosen the 2 bolts on the slide door down male stop (body side).

  1. B058863
    When adjusting the door rear laterally, and the slide door lock striker plate assembly horizontally and vertically, use "TORX" socket wrench T40 to loosen the screws until the striker can move. Lightly tap it with a brass bar for adjustment.

    Torque:
    23 N*m{ 235 kgf*cm , 17 ft.*lbf }

  1. B101164
    Using SST, loosen the bolts on the slide door center hinge to adjust the slide door rear vertically and horizontally.
    SST
    09812-00010  

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }

  1. B101166
    Loosen the nuts on the slide door upper roller to adjust the slide door upper front laterally.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }

  1. B102801
    Loosen the bolts on the slide door lower roller to adjust the slide door front lower laterally (body side), horizontally and vertically.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }

    HINT:
    1. When adjusting the slide door lower roller (door side), remove the rear door trim board.
    2. When adjusting the slide door lower roller base (body side), remove the slide door full open stop. Temporarily tighten the bolts.

  1. Temporarily tighten the 2 bolts on the slide door down male stopper (body side), completely close the slide door to confirm the position. Fully tighten the 2 bolts on the slide door down male stopper (body side).

  1. Connect the negative (-) battery terminal to the cable.

  1. Initialize both systems.

  1. Inspect the SRS warning light.

  1. After completing the fitting adjustment, make sure that the electric door lock and the power slide door operate normally.

← DISASSEMBLY (from Oct 2014)REASSEMBLY (from Oct 2014) →