2014-2019 Hiace · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Jan 2015

Versions by build date: Oct 2014 – Dec 2014 from Jan 2015


1. INSTALL OIL FILTER SUB-ASSEMBLY (for Type A)

  1. G037462E01
    Check and clean the oil filter installation surface.

  1. Apply clean engine oil to the gasket of a new oil filter sub-assembly.

  1. Lightly screw the oil filter sub-assembly into place, and tighten it until the gasket contacts the seat.

  1. A099196E02
    Using SST, tighten the oil filter sub-assembly.
    SST
    09228-07501  

    When using a torque wrench:
    Tighten the oil filter sub-assembly.

    Torque:
    17 N*m{ 175 kgf*cm , 13 ft.*lbf }

    When not using a torque wrench:
    Tighten the oil filter sub-assembly an additional 3/4 turn.


2. INSTALL OIL FILTER ELEMENT (for Type B)
  1. Clean the inside of the oil filter cap, its threads and its O-ring groove.

  1. A268595E01
    Apply a small amount of engine oil to a new O-ring (for cap) and install it to the oil filter cap.
    Text in Illustration 
    *1
    O-Ring (for Cap)
    *a
    CORRECT
    *b
    INCORRECT

    NOTICE:
    1. Be sure to install the O-ring (for cap) in the proper location, otherwise oil may leak.
    2. Do not twist the O-ring (for cap).

  1. Set a new oil filter element in the oil filter cap.

  1. Remove any dirt or foreign matter from the installation surface of the engine.

  1. Apply a small amount of engine oil to the O-ring (for cap) again and temporarily install the oil filter cap.

  1. A309157E01
    Using SST, tighten the oil filter cap.
    SST
    09228-06501  

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }

    Text in Illustration 
    *1
    Oil Filter Cap
    *2
    O-Ring (for Cap)
    *3
    Oil Filter Bracket
    *a
    No Gap


3. ADD ENGINE OIL
  1. Add fresh engine oil.

    Standard Capacity:
    Item
    Specified Condition
    Drain and refill without oil filter change
    4.9 liters (5.2 US qts, 4.3 Imp. qts)
    Drain and refill with oil filter change
    5.3 liters (5.6 US qts, 4.7 Imp. qts)
    Dry fill
    6.7 liters (7.1 US qts, 5.9 Imp. qts)

  1. Install the oil filler cap.


4. INSPECT FOR OIL LEAK
  1. Start the engine. Make sure that there are no oil leaks from the areas that were worked on.


5. INSTALL ENGINE UNDER COVER NO. 2 (for Narrow Body, w/ Engine Under Cover No. 2)

Torque:
13 N*m{ 133 kgf*cm , 10 ft.*lbf }


6. INSTALL ENGINE SIDE UNDER COVER RH (for Wide Body, w/ Engine Side Under Cover RH)

Torque:
13 N*m{ 133 kgf*cm , 10 ft.*lbf }

← INSTALLATION (Oct 2014 – Dec 2014)ON-VEHICLE INSPECTION (from Oct 2014) →