2014-2019 Hiace · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built Oct 2014 – Dec 2014

Versions by build date: Oct 2014 – Dec 2014 from Jan 2015


1. INSTALL OIL FILTER SUB-ASSEMBLY

  1. G037462E01
    Check and clean the oil filter installation surface.

  1. Apply clean engine oil to the gasket of a new oil filter.

  1. Lightly screw the oil filter into place, and tighten it until the gasket contacts the seat.

  1. A099196E02
    Using SST, tighten the oil filter.
    SST
    09228-07501  

    When using a torque wrench:
    Tighten the oil filter.

    Torque:
    17 N*m{ 175 kgf*cm , 13 ft.*lbf }

    When not using a torque wrench:
    Tighten the oil filter an additional 3/4 turn.


2. ADD ENGINE OIL
  1. Add fresh engine oil.

    Standard Capacity:
    Item
    Capacity
    Drain and refill without oil filter change
    5.0 liters (5.3 US qts, 4.4 Imp. qts)
    Drain and refill with oil filter change
    5.5 liters (5.8 US qts, 4.8 Imp. qts)
    Dry fill
    6.2 liters (6.5 US qts, 5.4 Imp. qts)

  1. Install the oil filler cap.


3. INSPECT FOR OIL LEAK
  1. Start the engine. Make sure that there are no oil leaks from the areas that were worked on.


4. INSTALL ENGINE UNDER COVER NO.2 (for Narrow Body, w/ Engine Under Cover No.2)

Torque:
13 N*m{ 133 kgf*cm , 10 ft.*lbf }


5. INSTALL ENGINE SIDE UNDER COVER RH (for Wide Body, w/ Engine Side Under Cover RH)

Torque:
13 N*m{ 133 kgf*cm , 10 ft.*lbf }

← REMOVAL (from Jan 2015)INSTALLATION (from Jan 2015) →