2014-2019 Hiace · Service Manual BRAKE

REASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. INSTALL LOAD SENSING SPRING BUSH & BOOT KIT

  1. C102676E01
    Apply lithium soap base glycol grease to the parts shown in the illustration.

  1. C102746
    Install a new valve boot and a new spring boot to the spring assembly.

  1. Install a new load sensing spring bush No.1, No.2, collar and the plate washer to the valve boot.

  1. C102745
    Install the spring shackle No.1, plate washer, nut and the lock nut to the spring shackle No.2.

  1. C102747
    Place the spring shackle in the vise.

  1. With the 2 plate washers on both sides of the load sensing spring boot, insert the bolt through the washers, spring shackle No.1, and spring boot.

  1. Tighten the nut while holding the bolt.

    Torque:
    18 N*m{ 185 kgf*cm , 13 ft.*lbf }

  1. C102673
    Install the 2 shackle bushes and the collar to the spring shackle No.2.

  1. Install the bolt and spring shackle No.2 to the load sensing spring bracket.

    Torque:
    12.5 N*m{ 130 kgf*cm , 9 ft.*lbf }

  1. C102748E01
    Turn the nut and lock nut so that dimension A, shown in the illustration, is adjusted to approximately 120 mm (4.724 in.).

    Torque:
    12.5 N*m{ 130 kgf*cm , 9 ft.*lbf }


2. INSTALL LOAD SENSING PROPORTIONING VALVE ASSEMBLY

  1. C061313
    Install the valve boot to the load sensing proportioning valve assembly.

  1. C102671E01
    Place the load sensing proportioning valve assembly in the vise.

  1. Install the load sensing spring assembly to the load sensing valve boot with the 2 washers, bolt, and nut.

    Torque:
    18 N*m{ 185 kgf*cm , 13 ft.*lbf }

    HINT:
    Tighten the nut while holding the bolt.

  1. Install the valve bracket with the 2 spring washers, valve set plate, and 2 nuts.

    Torque:
    12.5 N*m{ 130 kgf*cm , 9 ft.*lbf }

← DISASSEMBLY (from Oct 2014)INSTALLATION (Oct 2014 – Dec 2014) →