2014-2019 Hiace · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Jan 2017


1. INSTALL ENGINE WATER PUMP ASSEMBLY

  1. A343591E01
    Temporarily install a new gasket and the water pump assembly with the 8 bolts.

    Standard Length:
    Item
    Specified Condition
    Bolt A
    45 mm (1.77 in.)
    Bolt B
    65 mm (2.56 in.)

    Text in Illustration 
    V100135
    Bolt A
    V100136
    Bolt B

  1. Tighten the 8 bolts in the order shown in the illustration.

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }


2. CONNECT NO. 1 TURBO WATER HOSE
  1. Connect the No. 1 turbo water hose to the engine water pump assembly, and slide the clamp to secure the hose.


3. INSTALL NO. 1 WATER BY-PASS PIPE

  1. A397683E01
    Install a new gasket to the No. 1 water by-pass pipe as shown in the illustration.
    Text in Illustration 
    *a
    Claw

    HINT:
    Make sure that the claws of the gasket are facing the water by-pass pipe.

  1. Install the No. 1 water by-pass pipe to the engine water pump assembly with the 2 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }


4. INSTALL THERMOSTAT
(Click here)
← REMOVAL (from Jan 2017)COMPONENTS (from Jan 2017) →