2014-2019 Hiace · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT STEERING PAD SWITCH LH

  1. Inspect the steering pad switch LH.

    1. Measure the resistance according to the value(s) in the table below.

      E289394E01

      Text in Illustration 
      *1
      VOL-
      *2
      VOL+
      *3
      SEEK-
      *4
      SEEK+
      *5
      MODE
      *6
      Horn Wire
      *a
      Component without harness connected
      (Steering Pad Switch LH)
      -
      -
      Standard Resistance 
      Tester Connection
      Switch Condition
      Specified Condition
      11 (AU1) - 8 (EAU)
      No switch pushed
      95 to 105 kΩ
      VOL+ switch pushed
      950 to 1050 Ω
      VOL- switch pushed
      2955 to 3265 Ω
      SEEK+ switch pushed
      Below 2.5 Ω
      SEEK- switch pushed
      313 to 345 Ω
      MODE switch pushed
      95 to 105 kΩ
      A10 (AU2) - A8 (EAU)
      No switch pushed
      95 to 105 kΩ
      VOL+ switch pushed
      VOL- switch pushed
      SEEK+ switch pushed
      SEEK- switch pushed
      MODE switch pushed
      Below 2.5 Ω
      1(HO) - Horn Wire
      Always
      Below 2.5 Ω
      If the result is not as specified, replace the steering pad switch LH.

  1. Check the illumination.

    1. Connect the battery positive (+) lead to terminal 5(IL+2) and the negative (-) lead to terminal 8(EAU) of the steering pad switch LH connector.

    2. Check that the steering pad switch LH illumination comes on.

      OK:
      Steering pad switch illumination comes on.

      If the result is not as specified, replace the steering pad switch LH.

← REMOVAL (from Jan 2017)INSTALLATION (Oct 2014 – Mar 2016) →