ADJUSTMENT
Removal / installation · Vehicles built from Jan 2015
| 1. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
While pushing the shift lock release button, move the shift lever to N.
Remove the bolt of the park/neutral position switch assembly.
Clean the bolt and bolt hole.
Apply adhesive to 2 or 3 threads on the end of the bolt.
- Adhesive:
- Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
Align the neutral basic line with the groove as shown in the illustration.

Text in Illustration *a
Neutral Basic Line
*b
Groove
Hold the park/neutral position switch assembly in position and install the bolt.
- Torque:
- 13 N*m{ 130 kgf*cm , 9 ft.*lbf }
After the adjustment, perform the park/neutral position switch assembly operation check.
(Click here)
