INSPECTION
Inspection · Vehicles built from Jan 2015
| INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY |
Using a dial indicator, measure the inside diameter of the front oil pump body sub-assembly bushing.

- Maximum inside diameter:
- 38.138 mm (1.50 in.)
| INSPECT STATOR SHAFT ASSEMBLY |
Using a dial indicator, measure the inside diameter of the stator shaft assembly bushing.

- Maximum inside diameter:
- 22.227 mm (0.875 in.)
| INSPECT CLEARANCE OF OIL PUMP ASSEMBLY |
Push the front oil pump driven gear to one side of the front oil pump body sub-assembly.

Using a feeler gauge, measure the clearance.
- Standard body clearance:
- 0.10 to 0.17 mm (0.00394 to 0.00669 in.)
Using a feeler gauge, measure the clearance between the front oil pump driven gear teeth and the front oil pump drive gear teeth.

- Standard tip clearance:
- 0.07 to 0.15 mm (0.00276 to 0.00590 in.)
Using a steel straightedge and a feeler gauge, measure the side clearance of both gears.

- Standard side clearance:
- 0.03 to 0.05 mm (0.00118 to 0.00196 in.)
| INSPECT OIL PUMP DRIVE GEAR ROTATION |
Install the oil pump assembly to the torque converter assembly.
Check that the front oil pump drive gear rotates smoothly.

Remove the oil pump assembly from the torque converter assembly.
