ON-VEHICLE INSPECTION
Inspection · Vehicles built from Jan 2017
| INSPECT INTAKE MASS AIR FLOW METER SUB-ASSEMBLY |
Read the value using the GTS (MAF).
- NOTICE:
- Perform the inspection of the intake mass air flow meter sub-assembly while it is installed to the air cleaner cap sub-assembly (installed to the vehicle).
Connect the GTS to the DLC3.
Start the engine.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Data List / MAF.
Wait for 30 seconds, and read the value on the GTS (Click here).
If the result is not as specified, replace the intake mass air flow meter sub-assembly.
If the result is within the specified range, inspect the intake mass air flow meter sub-assembly (Click here).
