2014-2019 Hiace · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built Oct 2014 – Dec 2014

Versions by build date: Oct 2014 – Dec 2014 from Jan 2015


INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    6.9 to 7.9 Ω

    If the result is not as specified, replace the camshaft timing oil control valve assembly.

  1. A123787E07
    Connect the positive (+) lead of the battery to terminal 1 and negative (-) lead to terminal 2, and check the movement of the spool valve.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) voltage is applied
    Valve moves in left arrow direction shown in illustration
    Battery positive (+) voltage is cut off
    Valve moves in right arrow direction shown in illustration

    Text in Illustration 
    *a
    Component without harness connected
    (Camshaft Timing Oil Control Valve Assembly)
    *b
    Spool Valve

    HINT:
    If the spool valve cannot return properly because of foreign matter, a small pressure leak in the advanced direction may occur and a DTC may be output.

    If the result is not as specified, replace the camshaft oil control valve assembly.

← REMOVAL (from Jan 2015)INSPECTION (from Jan 2015) →