2014-2019 Hiace · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Jan 2015

Versions by build date: Oct 2014 – Dec 2014 from Jan 2015


INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (w/ Dual VVT-i)
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      20°C (68°F)
      6.9 to 7.9 Ω

      If the result is not as specified, replace the camshaft timing oil control valve assembly.

  1. Check the operation.

    1. A341582E01
      Apply battery voltage between the terminals and check that the spool valve operates.

      OK:
      The spool valve is not stuck

      Text in Illustration 
      *a
      Component without harness connected
      (Camshaft Timing Oil Control Valve Assembly)
      *b
      When voltage is applied (advanced side)
      *c
      When voltage is not applied (retarded side)
      *d
      Spool Valve

      HINT:
      Problems in the spool valve returning caused by sticking of sludge or foreign objects sometimes cause slight pressure leaks to the advanced side and result in detection of DTCs.

      If the spool valve is stuck, replace the camshaft timing oil control valve assembly.


INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (w/o Dual VVT-i)
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      20°C (68°F)
      6.9 to 7.9 Ω

      If the result is not as specified, replace the camshaft timing oil control valve assembly.

  1. Check the operation.

    1. A099422E26
      Apply battery voltage between the terminals and check that the spool valve operates.

      OK:
      The spool valve is not stuck

      Text in Illustration 
      *a
      Component without harness connected
      (Camshaft Timing Oil Control Valve Assembly)
      *b
      When voltage is applied (advanced side)
      *c
      When voltage is not applied (retarded side)
      *d
      Spool Valve

      HINT:
      Problems in the spool valve returning caused by sticking of sludge or foreign objects sometimes cause slight pressure leaks to the advanced side and result in detection of DTCs.

      If the spool valve is stuck, replace the camshaft timing oil control valve assembly.

← INSPECTION (Oct 2014 – Dec 2014)INSTALLATION (Oct 2014 – Dec 2014) →