Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM
Headlight Signal Circuit
Circuit diagnosis · Vehicles built Jan 2015 – Mar 2016
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017
DESCRIPTION
The headlight leveling ECU receives low beam headlight on/off state information from the headlight relay to control the headlight beam level control system.
HINT:
Before performing troubleshooting of the automatic headlight beam level control system, check that the low beam headlights operate normally.
WIRING DIAGRAM
INSPECTION PROCEDURE
HINT:
After replacing the headlight leveling ECU, initialization of the ECU is necessary (Click here ).
1. READ VALUE USING GTS (HEADLIGHT)
Using the GTS, read the Data List (Click here ).
HL Auto Leveling
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Headlight Low Beam State
Low beam headlight state / ON or OFF
ON: Low beam headlights on OFF: Low beam headlights off
-
OK:
The display is as specified in the normal condition column.
NG
OK
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here )
2. CHECK HARNESS AND CONNECTOR (HEADLIGHT SIGNAL CIRCUIT)
Disconnect the A39 headlight leveling ECU connector.
Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
A39-4 (HDLP) - Body ground
Headlight dimmer switch off
11 to 14 V
Headlight dimmer switch head
Below 1 V
Text in Illustration
*a
Front view of wire harness connector (to Headlight Leveling ECU Assembly)
Result
Result
Proceed to
OK (for LHD)
A
OK (for RHD)
B
NG
C
B
REPLACE HEADLIGHT LEVELING ECU ASSEMBLY (Click here )
C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A
REPLACE HEADLIGHT LEVELING ECU ASSEMBLY (Click here )