2014-2019 Hiace · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built from Oct 2014


1. REMOVE ENGINE UNDER COVER NO.1

2. REMOVE ENGINE UNDER COVER NO.2

3. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER

  1. B365544
    Using a clip remover, remove the 2 clips.

  1. Detach the 4 clips and remove the instrument panel finish lower.

  1. Disconnect each connector.

  1. B102838
    Push the positions indicated by the arrows in the illustration to disconnect the fuel lid lock control cable and bonnet (hood) control cable assembly from the instrument panel finish lower.


4. REMOVE INSTRUMENT PANEL UNDER COVER ASSEMBLY NO.1

  1. B365546
    Using a clip remover, remove the 2 clips

  1. Detach the 3 claws and remove the instrument panel under cover sub-assembly No. 1.


5. REMOVE PARKING BRAKE HOLE COVER

  1. B365547
    Detach the 6 claws and remove the parking brake hole cover.

  1. Disconnect each connector.


6. REMOVE INSTRUMENT PANEL TO FLOOR BRACE SUB-ASSEMBLY (LHD)

  1. E107295
    Remove the 5 bolts and the instrument panel to floor brace sub-assembly.


7. REMOVE PARKING BRAKE CONTROL HANDLE ASSEMBLY (LHD)
  1. Release the parking brake control handle.

  1. C105455
    Remove the 2 bolts.

  1. C105456
    Disconnect the parking brake switch connector.

  1. C105457
    Lower the parking brake control handle.

  1. C105458
    Remove the 2 nuts, and separate the brake control handle assembly from body.

  1. Remove the 4 bolts, and separate the parking brake cable assembly No.1 from the body. (Procedure A)

    C102157E01

  1. Separate the parking brake cable assembly No.1 from the parking brake equalizer. (Procedure B)

  1. Remove the clamps.

  1. C105459
    Remove the 2 bolts and separate the parking brake cable assembly No.1 from the body.

  1. Pull the parking brake cable assembly No.1 into the cabin and remove the parking brake control handle.


8. REMOVE PARKING BRAKE CONTROL HANDLE ASSEMBLY (RHD)
  1. Release the parking brake control handle.

  1. C102143
    Remove the 2 bolts.

  1. C102144
    Disconnect the parking brake switch connector.

  1. C102850
    Lower the parking brake control handle.

  1. C102145
    Remove the 2 nuts, and separate the parking brake control handle assembly.

  1. Remove the 4 bolts, and separate the parking brake cable assembly No.1 from the body. (Procedure A)

    C102157E01

  1. Separate the parking brake cable assembly No.1 from the parking brake equalizer. (Procedure B)

  1. Remove the clamps.

  1. C102156
    Remove the 2 bolts and separate the parking brake cable assembly No.1 from the body.

  1. Pull the parking brake cable assembly No.1 into the cabin and remove it from the driver side together with the parking brake control handle.

← COMPONENTS (from Oct 2014)DISASSEMBLY (from Oct 2014) →