2014-2019 Hiace · Service Manual BRAKE

DISASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. REMOVE PARKING BRAKE CABLE ASSEMBLY NO.1

  1. C106071
    Remove the parking brake plunger protector.

  1. C106072
    Remove the clip.

  1. C106073
    Remove the clip from the parking brake wire hole pin.

  1. C106074
    Remove the parking brake wire hole pin and the parking brake wire pulley.

  1. C102857E01
    Remove the parking brake switch assembly.

  1. C106076E01
    Move the parking brake pawl (A) to release the lock, and push in the parking brake plunger assembly (B) as shown in the illustration.

  1. C106077
    Separate the parking brake cable assembly No.1 from the parking brake plunger assembly.

  1. C106078
    Remove the parking brake cable assembly No.1 from the bracket.


2. REMOVE PARKING BRAKE PLUNGER ASSEMBLY

  1. C106079
    Using a punch (φ3 mm) and hammer, remove the parking brake plunger pin.

  1. C102856
    Using a small screwdriver, remove the parking brake plunger anti-rattle.

    HINT:
    1. Turn the parking brake anti-rattle, and remove it from its end.
    2. Tape up the screwdriver tip before use.

  1. Remove the parking brake plunger assembly from the parking brake plunger guide.

  1. C106080
    Using a small screwdriver, remove the parking brake plunger bushing.

    NOTICE:
    Do not damage the plunger guide.

    HINT:
    Tape up the screwdriver tip before use.

  1. C106081
    Using a drill (φ4mm), remove the staking part of the parking brake pawl pin.

    NOTICE:
    Do not damage the plunger guide.

  1. Remove the 2 parking brake pawl pins, 2 parking brake pawls and 2 springs.

← REMOVAL (from Oct 2014)REASSEMBLY (from Oct 2014) →