2014-2019 Hiace · Service Manual BRAKE

REASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. INSTALL PARKING BRAKE PLUNGER ASSEMBLY
  1. Apply MP grease to 2 new parking brake pawls and 2 pins.

  1. Install the 2 parking brake pawls and springs to the parking brake plunger guide.

  1. Install the 2 parking brake pawl pins.

  1. C106082
    Holding one side of the parking brake pawl pin with a metal block, tap the other side with a hammer to stake it.

    NOTICE:
    Do not damage the plunger guide.

  1. C106080
    Using a screwdriver, install a new parking brake bush to the parking brake plunger guide.

    NOTICE:
    Do not damage the plunger guide.

    HINT:
    Tape up the screwdriver tip before use.

  1. C106083E01
    Move the 2 parking brake pawls (A) to release the lock, and push in the parking brake plunger assembly (B) as shown in the illustration.

  1. C113652E01
    Install a new parking brake plunger anti-rattle to the parking brake plunger assembly.

  1. C102708E01
    Using a hammer, install the parking brake plunger pin in the position shown in the illustration.

    NOTICE:
    Install the plunger pin parallel to the parking brake switch bracket.


2. INSTALL PARKING BRAKE CABLE ASSEMBLY NO.1

  1. C106078
    Install the parking brake cable assembly No.1 to the bracket.

  1. C106076E01
    Move the parking brake pawl (A) to release the lock, and push in the parking brake plunger assembly as shown in the illustration (B).

  1. C106085E01
    Connect the parking brake cable assembly No.1 to the parking brake plunger assembly.

  1. Install the bracket to the parking brake plunger guide.

  1. C106086E01
    Apply MP grease to the parking brake wire pawl pin.

  1. Push the parking brake wire pulley as shown in the illustration, install the parking brake wire pawl pin.

  1. C106073
    Install the clip to the parking brake wire pawl pin.

  1. C106072
    Install the clip.

  1. C102857E01
    Install the parking brake switch.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }

  1. C106071
    Install the parking brake plunger protector.

← DISASSEMBLY (from Oct 2014)INSTALLATION (from Oct 2014) →