2014-2019 Hiace · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built from Oct 2014


1. REMOVE REAR WHEEL

2. REMOVE REAR BRAKE DRUM

  1. Release the parking brake lever, and remove the brake drum.

    C263541E01

    Text in Illustration 
    *A
    for 295 mm Drum
    *B
    for 254 mm Drum

    HINT:
    If the brake drum cannot be removed easily, perform the following steps.

  1. Remove the hole plug and insert a screwdriver through the hole in the backing plate, and hold the automatic adjusting lever away from the adjuster.

  1. Using another screwdriver, contract the brake shoe adjuster by turning the adjusting wheel.


3. REMOVE REAR AXLE BRAKE DRUM GASKET

4. REMOVE AUTOMATIC ADJUST LEVER

  1. for 254 mm drum:

    1. C102605
      Remove the automatic adjust lever and the tension spring.


5. SEPARATE PARKING BRAKE SHOE STRUT SET

  1. for 254 mm drum:

    1. C231698E01
      Using SST, remove the upper side tension spring from the brake shoe.
      SST
      09703-30011  

  1. for 295 mm drum:

    1. C263526E01
      Using SST, remove the upper side tension spring from the brake shoe.
      SST
      09703-30011  


6. REMOVE FRONT BRAKE SHOE

  1. for 254 mm drum:

    1. C102600
      Using a needle-nose pliers, remove the anchor side tension spring.

    2. C102601E01
      Using SST, remove the cup, shoe hold-down sprig and pin.
      SST
      09718-00011  

    3. C264220E02
      Remove the parking brake shoe lower strut.
      Text in Illustration 
      *A
      LH Side
      *B
      RH Side

    4. Separate the brake shoe return spring, and remove the front brake shoe.

  1. for 295 mm drum:

    1. C263527E01
      Using SST, remove the cup, shoe hold-down sprig and pin.
      SST
      09718-00011  

    2. Separate the brake shoe return spring, and remove the front brake shoe.


7. REMOVE REAR BRAKE SHOE

  1. for 254 mm drum:

    1. C102603E01
      Using SST, remove the cup, shoe hold-down sprig and pin.
      SST
      09718-00011  

    2. C102606
      Disconnect the parking brake cable No. 3 and remove the rear brake shoe.

  1. for 295 mm drum:

    1. C263528E01
      Using SST, remove the cup, shoe hold-down sprig and pin.
      SST
      09718-00011  

    2. Remove the tension spring.

    3. C263529
      Disconnect the parking brake cable No. 3 and remove the rear brake shoe.


8. REMOVE PARKING BRAKE CABLE ASSEMBLY NO.3 (NARROW BODY)

  1. C102159
    Remove the 2 bolts and separate the parking brake cable assembly No.3 from the backing plate.

  1. Remove the 5 bolts, nut and parking brake cable assembly No.3.

    C102158

  1. Remove the parking brake cable assembly No.3 from the parking brake equalizer.


9. REMOVE PARKING BRAKE CABLE ASSEMBLY NO.3 (WIDE BODY)

  1. C102159
    Remove the 2 bolts and separate the parking brake cable assembly No.3 from the backing plate.

  1. Remove the 6 bolts, nut and parking brake cable assembly No.3.

    C105462

  1. Remove the parking brake cable assembly No.3 from the parking brake equalizer.

← COMPONENTS (from Jan 2015)INSTALLATION (from Oct 2014) →