2014-2019 Hiace · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built Oct 2014 – Dec 2014

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017


1. PRECAUTION

CAUTION:
Be sure to read Precaution thoroughly before servicing (Click here).

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE LOWER NO. 3 STEERING WHEEL COVER

  1. B366168E01
    Put protective tape around the lower No. 3 steering wheel cover.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a screwdriver, detach the claw and guide and remove the lower No. 3 steering wheel cover.

    HINT:
    Tape the screwdriver tip before use.


4. REMOVE LOWER NO. 2 STEERING WHEEL COVER

  1. B366170E01
    Put protective tape around the lower No. 2 steering wheel cover.
    Text in Illustration 
    *A
    w/o Cruise Control System
    *B
    w/ Cruise Control System
    *1
    Protective Tape

  1. Using a screwdriver, detach the claw and guide and remove the lower No. 2 steering wheel cover.

    HINT:
    Tape the screwdriver tip before use.


5. REMOVE STEERING PAD

CAUTION:
When storing the steering pad, keep the airbag deployment side facing upward.

  1. Check that the ignition switch is off.

  1. Check that the cable is disconnected from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  1. Using a T30 "TORX" socket wrench, loosen the 2 "TORX" screws until the groove along the screw circumference catches on the screw case.

  1. Pull the steering pad toward you.

    B367173E01

    Text in Illustration 
    *A
    w/o Steering Pad Switch
    *B
    w/ Steering Pad Switch

  1. Disconnect the horn connector from the steering pad.

  1. Using a screwdriver, release the airbag connector lock.

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the airbag connector and remove the steering pad as shown in the illustration.

    NOTICE:
    When disconnecting any airbag connector, take care not to damage the airbag wire harness.


    B367174E01
    Text in Illustration 
    *A
    w/o Steering Pad Switch
    *B
    w/ Steering Pad Switch
    *1
    Protective Tape
    *2
    Connector Lock

← ON-VEHICLE INSPECTION (from Jan 2017)REMOVAL (Jan 2015 – Mar 2016) →