REMOVAL
Removal / installation · Vehicles built Apr 2016 – Dec 2016
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017
| 1. PRECAUTION |
- CAUTION:
- Be sure to read Precaution thoroughly before servicing (Click here).
- NOTICE:
- After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 3. REMOVE LOWER NO. 3 STEERING WHEEL COVER |
Put protective tape around the lower No. 3 steering wheel cover.

Text in Illustration *1
Protective Tape
Using a screwdriver, detach the claw and guide and remove the lower No. 3 steering wheel cover.
- HINT:
- Tape the screwdriver tip before use.
| 4. REMOVE LOWER NO. 2 STEERING WHEEL COVER |
Put protective tape around the lower No. 2 steering wheel cover.

Text in Illustration *A
w/o Cruise Control System
*B
w/ Cruise Control System
*1
Protective Tape
Using a screwdriver, detach the claw and guide and remove the lower No. 2 steering wheel cover.
- HINT:
- Tape the screwdriver tip before use.
| 5. REMOVE STEERING PAD |
- CAUTION:
- When storing the steering pad, keep the airbag deployment side facing upward.
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Using a T30 "TORX" socket wrench, loosen the 2 "TORX" screws until the groove along the screw circumference catches on the screw case.
Pull the steering pad toward you.


Text in Illustration *A
w/o Steering Pad Switch
*B
w/ Steering Pad Switch
Disconnect the horn connector from the steering pad.
Using a screwdriver, release the airbag connector lock.
- HINT:
- Tape the screwdriver tip before use.
Disconnect the airbag connector and remove the steering pad as shown in the illustration.
- NOTICE:
- When disconnecting any airbag connector, take care not to damage the airbag wire harness.


Text in Illustration *A
w/o Steering Pad Switch
*B
w/ Steering Pad Switch
*1
Protective Tape
*2
Connector Lock
