INSPECTION
Inspection · Vehicles built Oct 2014 – Dec 2014
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017
| INSPECT SPIRAL CABLE SUB-ASSEMBLY |
- NOTICE:
- As the spiral cable sub-assembly may break, do not rotate the spiral cable sub-assembly more than the specified amount.
Visually check for defects with the spiral cable sub-assembly.
The defects are as follows:
- Scratches
- Small cracks
- Dents
- Chips
- Cracks or other damage to the connector
- OK:
- No defects are found.
- Scratches
w/ Wire Harness:
Check the spiral cable sub-assembly.- NOTICE:
- When rotating the spiral cable sub-assembly, make sure to push on the interlock indicated in the illustration to release the interlock mechanism.
Set the spiral cable sub-assembly to the center position (Click here).
Measure the resistance between each terminal of the spiral cable sub-assembly according to the table below.


Text in Illustration *A
w/o Steering Pad Switch
*B
w/ Steering Pad Switch
*1
Interlock
-
-
*a
Component without harness connected
(Spiral Cable Sub-assembly)
-
-
- Standard Resistance:
w/o Steering Pad Switch: Tester Connection
Condition
Specified Condition
H78-1 - J1-2
Always
Below 1 Ω
H78-2 - J1-1
Always
Below 1 Ω
H77-1 - A-3
Always
3 Ω or less
H77-2 - A-4
Always
3 Ω or less
H77-9 - A-2
Always
3 Ω or less
w/ Steering Pad Switch: Tester Connection
Condition
Specified Condition
H78-1 - J1-2
Always
Below 1 Ω
H78-2 - J1-1
Always
Below 1 Ω
H77-1 - A-3
Always
3 Ω or less
H77-2 - A-4
Always
3 Ω or less
H77-2 - u3-7
Always
3 Ω or less
H77-3 - u3-8
Always
3 Ω or less
H77-4 - u3-9
Always
3 Ω or less
H77-5 - u3-10
Always
3 Ω or less
H77-6 - u3-11
Always
3 Ω or less
H77-7 - u3-12
Always
3 Ω or less
H77-8 - A-1
Always
3 Ω or less
H77-9 - u3-1
Always
3 Ω or less
H77-9 - A-2
Always
3 Ω or less
H77-10 - u3-2
Always
3 Ω or less
H77-11 - u3-3
Always
3 Ω or less
H77-12 - u3-4
Always
3 Ω or less
H77-13 - u3-5
Always
3 Ω or less
H77-14 - u3-6
Always
3 Ω or less
After setting the spiral cable sub-assembly to the center position, rotate the spiral cable sub-assembly 2.5 times clockwise, and measure the resistance as shown in the table below. Then rotate the spiral cable sub-assembly 5 times counterclockwise, and measure the resistance as shown in the table below.
- Standard Resistance:
w/o Steering Pad Switch: Tester Connection
Condition
Specified Condition
H78-1 - J1-2
Always
Below 1 Ω
H78-2 - J1-1
Always
Below 1 Ω
H77-1 - A-3
Always
3 Ω or less
H77-2 - A-4
Always
3 Ω or less
H77-9 - A-2
Always
3 Ω or less
w/ Steering Pad Switch: Tester Connection
Condition
Specified Condition
H78-1 - J1-2
Always
Below 1 Ω
H78-2 - J1-1
Always
Below 1 Ω
H77-1 - A-3
Always
3 Ω or less
H77-2 - A-4
Always
3 Ω or less
H77-2 - u3-7
Always
3 Ω or less
H77-3 - u3-8
Always
3 Ω or less
H77-4 - u3-9
Always
3 Ω or less
H77-5 - u3-10
Always
3 Ω or less
H77-6 - u3-11
Always
3 Ω or less
H77-7 - u3-12
Always
3 Ω or less
H77-8 - A-1
Always
3 Ω or less
H77-9 - u3-1
Always
3 Ω or less
H77-9 - A-2
Always
3 Ω or less
H77-10 - u3-2
Always
3 Ω or less
H77-11 - u3-3
Always
3 Ω or less
H77-12 - u3-4
Always
3 Ω or less
H77-13 - u3-5
Always
3 Ω or less
H77-14 - u3-6
Always
3 Ω or less
After setting the spiral cable sub-assembly to the center position, rotate the spiral cable sub-assembly 2.5 times clockwise. Then while rotating the spiral cable sub-assembly 5 times counterclockwise, measure the resistance as shown in the table below.
- Standard Resistance:
w/o Steering Pad Switch: Tester Connection
Condition
Specified Condition
H78-1 - J1-2
Always
Below 1 Ω
H78-2 - J1-1
Always
Below 1 Ω
H77-1 - A-3
Always
3 Ω or less
H77-2 - A-4
Always
3 Ω or less
H77-9 - A-2
Always
3 Ω or less
w/ Steering Pad Switch: Tester Connection
Condition
Specified Condition
H78-1 - J1-2
Always
Below 1 Ω
H78-2 - J1-1
Always
Below 1 Ω
H77-1 - A-3
Always
3 Ω or less
H77-2 - A-4
Always
3 Ω or less
H77-2 - u3-7
Always
3 Ω or less
H77-3 - u3-8
Always
3 Ω or less
H77-4 - u3-9
Always
3 Ω or less
H77-5 - u3-10
Always
3 Ω or less
H77-6 - u3-11
Always
3 Ω or less
H77-7 - u3-12
Always
3 Ω or less
H77-8 - A-1
Always
3 Ω or less
H77-9 - u3-1
Always
3 Ω or less
H77-9 - A-2
Always
3 Ω or less
H77-10 - u3-2
Always
3 Ω or less
H77-11 - u3-3
Always
3 Ω or less
H77-12 - u3-4
Always
3 Ω or less
H77-13 - u3-5
Always
3 Ω or less
H77-14 - u3-6
Always
3 Ω or less
w/o Wire Harness:

Check the spiral cable sub-assembly.- NOTICE:
- When rotating the spiral cable sub-assembly, make sure to push on the interlock indicated in the illustration to release the interlock mechanism.
Set the spiral cable sub-assembly to the center position (Click here).
Measure the resistance between each terminal of the spiral cable sub-assembly according to the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
H77-1 - A-3
Always
3 Ω or less
H77-2 - A-4
Always
3 Ω or less
H77-9 - A-2
Always
3 Ω or less
After setting the spiral cable sub-assembly to the center position, rotate the spiral cable sub-assembly 2.5 times clockwise, and measure the resistance as shown in the table below. Then rotate the spiral cable sub-assembly 5 times counterclockwise, and measure the resistance as shown in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
H77-1 - A-3
Always
3 Ω or less
H77-2 - A-4
Always
3 Ω or less
H77-9 - A-2
Always
3 Ω or less
After setting the spiral cable sub-assembly to the center position, rotate the spiral cable sub-assembly 2.5 times clockwise. Then while rotating the spiral cable sub-assembly 5 times counterclockwise, measure the resistance as shown in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
H77-1 - A-3
Always
3 Ω or less
H77-2 - A-4
Always
3 Ω or less
H77-9 - A-2
Always
3 Ω or less
Text in Illustration *1
Interlock
*a
Component without harness connected
(Spiral Cable Sub-assembly)
