2014-2019 Hiace · Service Manual RESTRAINTS

INSPECTION

Inspection · Vehicles built from Jan 2017

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017


INSPECT SPIRAL CABLE SUB-ASSEMBLY

NOTICE:
As the spiral cable sub-assembly may break, do not rotate the spiral cable sub-assembly more than the specified amount.

  1. Visually check for defects with the spiral cable sub-assembly.

    1. The defects are as follows:

      1. Scratches
      2. Small cracks
      3. Dents
      4. Chips
      5. Cracks or other damage to the connector

      OK:
      No defects are found.

      If any of the defects is found, replace the spiral cable sub-assembly with a new one.

  1. w/ Wire Harness:
    Check the spiral cable sub-assembly.

    NOTICE:
    When rotating the spiral cable sub-assembly, make sure to push on the interlock indicated in the illustration to release the interlock mechanism.


    1. Set the spiral cable sub-assembly to the center position (Click here).

    2. Measure the resistance between each terminal of the spiral cable sub-assembly according to the table below.

      B366642E01

      Text in Illustration 
      *A
      w/o Steering Pad Switch
      *B
      w/ Steering Pad Switch
      *1
      Interlock
      -
      -
      *a
      Component without harness connected
      (Spiral Cable Sub-assembly)
      -
      -

      Standard Resistance:
      w/o Steering Pad Switch: 
      Tester Connection
      Condition
      Specified Condition
      H78-1 - J1-2
      Always
      Below 1 Ω
      H78-2 - J1-1
      Always
      Below 1 Ω
      H77-1 - A-3
      Always
      3 Ω or less
      H77-2 - A-4
      Always
      3 Ω or less
      H77-9 - A-2
      Always
      3 Ω or less
      w/ Steering Pad Switch: 
      Tester Connection
      Condition
      Specified Condition
      H78-1 - J1-2
      Always
      Below 1 Ω
      H78-2 - J1-1
      Always
      Below 1 Ω
      H77-1 - A-3
      Always
      3 Ω or less
      H77-2 - A-4
      Always
      3 Ω or less
      H77-2 - u3-7
      Always
      3 Ω or less
      H77-3 - u3-8
      Always
      3 Ω or less
      H77-4 - u3-9
      Always
      3 Ω or less
      H77-5 - u3-10
      Always
      3 Ω or less
      H77-6 - u3-11
      Always
      3 Ω or less
      H77-7 - u3-12
      Always
      3 Ω or less
      H77-8 - A-1
      Always
      3 Ω or less
      H77-9 - u3-1
      Always
      3 Ω or less
      H77-9 - A-2
      Always
      3 Ω or less
      H77-10 - u3-2
      Always
      3 Ω or less
      H77-11 - u3-3
      Always
      3 Ω or less
      H77-12 - u3-4
      Always
      3 Ω or less
      H77-13 - u3-5
      Always
      3 Ω or less
      H77-14 - u3-6
      Always
      3 Ω or less

    3. After setting the spiral cable sub-assembly to the center position, rotate the spiral cable sub-assembly 2.5 times clockwise, and measure the resistance as shown in the table below. Then rotate the spiral cable sub-assembly 5 times counterclockwise, and measure the resistance as shown in the table below.

      Standard Resistance:
      w/o Steering Pad Switch: 
      Tester Connection
      Condition
      Specified Condition
      H78-1 - J1-2
      Always
      Below 1 Ω
      H78-2 - J1-1
      Always
      Below 1 Ω
      H77-1 - A-3
      Always
      3 Ω or less
      H77-2 - A-4
      Always
      3 Ω or less
      H77-9 - A-2
      Always
      3 Ω or less
      w/ Steering Pad Switch: 
      Tester Connection
      Condition
      Specified Condition
      H78-1 - J1-2
      Always
      Below 1 Ω
      H78-2 - J1-1
      Always
      Below 1 Ω
      H77-1 - A-3
      Always
      3 Ω or less
      H77-2 - A-4
      Always
      3 Ω or less
      H77-2 - u3-7
      Always
      3 Ω or less
      H77-3 - u3-8
      Always
      3 Ω or less
      H77-4 - u3-9
      Always
      3 Ω or less
      H77-5 - u3-10
      Always
      3 Ω or less
      H77-6 - u3-11
      Always
      3 Ω or less
      H77-7 - u3-12
      Always
      3 Ω or less
      H77-8 - A-1
      Always
      3 Ω or less
      H77-9 - u3-1
      Always
      3 Ω or less
      H77-9 - A-2
      Always
      3 Ω or less
      H77-10 - u3-2
      Always
      3 Ω or less
      H77-11 - u3-3
      Always
      3 Ω or less
      H77-12 - u3-4
      Always
      3 Ω or less
      H77-13 - u3-5
      Always
      3 Ω or less
      H77-14 - u3-6
      Always
      3 Ω or less

    4. After setting the spiral cable sub-assembly to the center position, rotate the spiral cable sub-assembly 2.5 times clockwise. Then while rotating the spiral cable sub-assembly 5 times counterclockwise, measure the resistance as shown in the table below.

      Standard Resistance:
      w/o Steering Pad Switch: 
      Tester Connection
      Condition
      Specified Condition
      H78-1 - J1-2
      Always
      Below 1 Ω
      H78-2 - J1-1
      Always
      Below 1 Ω
      H77-1 - A-3
      Always
      3 Ω or less
      H77-2 - A-4
      Always
      3 Ω or less
      H77-9 - A-2
      Always
      3 Ω or less
      w/ Steering Pad Switch: 
      Tester Connection
      Condition
      Specified Condition
      H78-1 - J1-2
      Always
      Below 1 Ω
      H78-2 - J1-1
      Always
      Below 1 Ω
      H77-1 - A-3
      Always
      3 Ω or less
      H77-2 - A-4
      Always
      3 Ω or less
      H77-2 - u3-7
      Always
      3 Ω or less
      H77-3 - u3-8
      Always
      3 Ω or less
      H77-4 - u3-9
      Always
      3 Ω or less
      H77-5 - u3-10
      Always
      3 Ω or less
      H77-6 - u3-11
      Always
      3 Ω or less
      H77-7 - u3-12
      Always
      3 Ω or less
      H77-8 - A-1
      Always
      3 Ω or less
      H77-9 - u3-1
      Always
      3 Ω or less
      H77-9 - A-2
      Always
      3 Ω or less
      H77-10 - u3-2
      Always
      3 Ω or less
      H77-11 - u3-3
      Always
      3 Ω or less
      H77-12 - u3-4
      Always
      3 Ω or less
      H77-13 - u3-5
      Always
      3 Ω or less
      H77-14 - u3-6
      Always
      3 Ω or less

      If the result is not as specified, replace the spiral cable sub-assembly.

  1. B367178E01
    w/o Wire Harness:
    Check the spiral cable sub-assembly.

    NOTICE:
    When rotating the spiral cable sub-assembly, make sure to push on the interlock indicated in the illustration to release the interlock mechanism.


    1. Set the spiral cable sub-assembly to the center position (Click here).

    2. Measure the resistance between each terminal of the spiral cable sub-assembly according to the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      H77-1 - A-3
      Always
      3 Ω or less
      H77-2 - A-4
      Always
      3 Ω or less
      H77-9 - A-2
      Always
      3 Ω or less

    3. After setting the spiral cable sub-assembly to the center position, rotate the spiral cable sub-assembly 2.5 times clockwise, and measure the resistance as shown in the table below. Then rotate the spiral cable sub-assembly 5 times counterclockwise, and measure the resistance as shown in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      H77-1 - A-3
      Always
      3 Ω or less
      H77-2 - A-4
      Always
      3 Ω or less
      H77-9 - A-2
      Always
      3 Ω or less

    4. After setting the spiral cable sub-assembly to the center position, rotate the spiral cable sub-assembly 2.5 times clockwise. Then while rotating the spiral cable sub-assembly 5 times counterclockwise, measure the resistance as shown in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      H77-1 - A-3
      Always
      3 Ω or less
      H77-2 - A-4
      Always
      3 Ω or less
      H77-9 - A-2
      Always
      3 Ω or less

      If the result is not as specified, replace the spiral cable sub-assembly.
      Text in Illustration 
      *1
      Interlock
      *a
      Component without harness connected
      (Spiral Cable Sub-assembly)

← INSPECTION (Apr 2016 – Dec 2016)INSTALLATION (Oct 2014 – Dec 2014) →