Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SPIRAL CABLE
REMOVAL
Removal / installation · Vehicles built Apr 2016 – Dec 2016
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017
1.
PRECAUTION
CAUTION:
Be sure to read Precaution thoroughly before servicing (Click here ).
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here ).
2.
PLACE FRONT WHEELS FACING STRAIGHT AHEAD
3.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here ).
4.
REMOVE STEERING PAD
(Click here )
5.
REMOVE STEERING WHEEL ASSEMBLY
Remove the steering wheel set nut.
Put matchmarks on the steering wheel assembly and steering main shaft assembly.
Text in Illustration
*a
Matchmark
*b
Hold
*c
Turn
Using SST, remove the steering wheel assembly.
SST
09950-50013
(09951-05010, 09952-05010, 09953-05020, 09954-05021)
NOTICE:
Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.
6.
REMOVE NO. 2 STEERING COLUMN LOWER COVER (w/ Smart Entry and Start System)
Detach the 4 claws and remove the No. 2 steering column lower cover.
7.
REMOVE LOWER STEERING COLUMN COVER
HINT:
Adjust the position of the steering tilt mechanism when performing the procedure.
Remove the 2 "TORX" screws (T25) from the steering column lower cover.
Push the steering column lower cover inward on both sides to detach the 2 claws.
Detach the 2 claws and remove the steering column lower cover.
8.
REMOVE COMBINATION METER ASSEMBLY
(Click here )
9.
REMOVE UPPER STEERING COLUMN COVER
Remove the steering column upper cover from the steering column assembly.
Text in Illustration
*a
Front of Vehicle
*b
Raise the backside of the steering column upper cover
*c
Pull diagonally backwards so that the claw of the steering column upper cover does not break
NOTICE:
If the steering column upper cover is removed by pulling it directly upwards, the claw may become damaged.
10.
REMOVE SPIRAL CABLE SUB-ASSEMBLY
NOTICE:
Do not replace the spiral cable sub-assembly with the battery connected and the ignition switch ON.
Do not rotate the spiral cable sub-assembly with the battery connected and the ignition switch ON.
Slide the slider to release the lock, and then disconnect the yellow airbag connector from the spiral cable sub-assembly.
Text in Illustration
*1
Slider
NOTICE:
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
Disconnect the connector from the spiral cable sub-assembly.
Detach the 3 claws and remove the spiral cable sub-assembly.