2014-2019 Hiace · Service Manual RESTRAINTS

INSTALLATION

Removal / installation · Vehicles built Oct 2014 – Dec 2014

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017


1. INSTALL AIR BAG SENSOR ASSEMBLY CENTER
  1. Check that the ignition switch is off.

  1. Check that the battery negative (-) terminal is disconnected.

    NOTICE:
    After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.

  1. C113667E01
    Using SST, install the center airbag sensor with the 3 bolts.
    SST
    09249-63010  

    Torque:
    17.5 N*m{ 179 kgf*cm , 13 ft.*lbf }

  1. Push the connector lever into the airbag sensor assembly center to connect and lock the airbag connector.

    NOTICE:
    Make sure that the connector is securely locked.

  1. Check that there is no looseness in the installation parts of the center airbag sensor.

  1. Check that the water-proof sheet is properly set.


2. INSTALL INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.1

3. CONNECT CABLE TO BATTERY NEGATIVE TERMINAL

4. INSPECT SUPPLEMENTAL RESTRAINT SYSTEM WARNING LIGHT
(Click here)

5. PERFORM INITIALIZATION
Some system need initialization when reconnecting battery cable. (Click here)
← REMOVAL (from Jan 2017)INSTALLATION (Jan 2015 – Mar 2016) →