2014-2019 Hiace · Service Manual RESTRAINTS

INSTALLATION

Removal / installation · Vehicles built Jan 2015 – Mar 2016

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017


1. INSTALL AIR BAG SENSOR ASSEMBLY CENTER
  1. Check that the ignition switch is off.

  1. Check that the battery negative (-) terminal is disconnected.

    NOTICE:
    After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.

  1. C113667E01
    Using SST, install the center airbag sensor with the 3 bolts.
    SST
    09249-63010  

    Torque:
    17.5 N*m{ 179 kgf*cm , 13 ft.*lbf }

  1. Push the connector lever into the airbag sensor assembly center to connect and lock the airbag connector.

    NOTICE:
    Make sure that the connector is securely locked.

  1. Check that there is no looseness in the installation parts of the center airbag sensor.

  1. Check that the water-proof sheet is properly set.


2. INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO. 1
  1. Attach the 3 claws to instrument panel under cover sub-assembly No. 1.

  1. Install the the 2 clips.


3. CONNECT CABLE TO BATTERY NEGATIVE TERMINAL

4. INSPECT SUPPLEMENTAL RESTRAINT SYSTEM WARNING LIGHT
(Click here)

5. PERFORM INITIALIZATION
Some system need initialization when reconnecting battery cable. (Click here)
← INSTALLATION (Oct 2014 – Dec 2014)INSTALLATION (Apr 2016 – Dec 2016) →