REASSEMBLY
Removal / installation · Vehicles built from Oct 2014
| 1.
INSTALL OIL SEAL |
 |
- Using SST and a hummer, tap in the oil seal.
- SST
- 09950-60010
(09951-00400)
09950-70010
(09951-07150)
| 2.
INSTALL O-RING |
 |
Apply the engine oil on a new O-ring and install the O-ring to the vacuum pump case.
| 3.
INSTALL VACUUM PUMP BEARING |
 |
- Using a press, install a new bearing to the pump shaft.
| 4.
INSTALL VACUUM PUMP SHAFT |
 |
Install the vacuum pump shaft and stop ring to the vacuum pump case.
| 5.
INSTALL VACUUM PUMP BLADE A |
 |
- Apply the engine oil on a rotor and the 5 new vacuum pump blades.
Install the rotor and the pump blades with the round end facing outward.
- Install the end plate with the 2 screws.
-
Torque:
- 2.0 N*m{
20 kgf*cm
, 17 in.*lbf
}
| 6.
INSTALL VACUUM PUMP END COVER |
 |
- Install the end cover with the 4 screws.
-
Torque:
- 4.6 N*m{
47 kgf*cm
, 41 in.*lbf
}
| 7.
INSTALL BRAKE VACUUM CHECK VALVE ASSEMBLY |
 |
- Using soft jaws, place vacuum pump in a vise, install a new gasket, and check valve.
-
Torque:
- 74 N*m{
750 kgf*cm
, 54 ft.*lbf
}
| 8.
INSTALL VACUUM PUMP VACUUM HOSE UNION |
 |
- Using SST, hold the check valve assembly, and install vacuum hose union with union bolt and 2 new gaskets.
- SST
- 09922-10010
-
Torque:
- 14 N*m{
140 kgf*cm
, 10 ft.*lbf
}
| 9.
INSTALL VACUUM PUMP PULLEY |
 |
- Install the vacuum pump pulley and pulley lock nut.
-
Torque:
- 105 N*m{
1,075 kgf*cm
, 78 ft.*lbf
}