INSPECTION
Inspection · Vehicles built from Oct 2014
| INSPECT BRAKE CYLINDER AND PISTON |
Check the cylinder bore and piston for rust or scoring.
| INSPECT FRONT DISC BRAKE PAD THICKNESS |
Using a ruler, measure the pad lining thickness.
- Standard thickness:
- 10.0 mm (0.390 in.)
- Minimum thickness:
- 1.0 mm (0.039 in.)
| INSPECT FRONT DISC BRAKE PAD SUPPORT PLATE NO.1 |
Make sure that the pad support plate No.1 has sufficient rebound, has no deformation, cracks or wear, and that all rust and dirt are cleaned off. If necessary, replace the brake pad support plate No.1.
| INSPECT FRONT DISC BRAKE PAD SUPPORT PLATE NO.2 |
Make sure that the pad support plate No.2 has sufficient rebound, has no deformation, cracks or wear, and that all rust and dirt are cleaned off. If necessary, replace the brake pad support plate No.2.
| INSPECT BRAKE DISC THICKNESS |
Using a micrometer, measure the disc thickness.
- Standard thickness:
- 28.0 mm (1.102 in.)
- Minimum thickness:
- 26.0 mm (1.024 in.)
