2014-2019 Hiace · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built from Jan 2015

Versions by build date: Oct 2014 – Dec 2014 from Jan 2015

HINT:
  1. Other than areas where instructions are provided, use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. REMOVE FRONT SEAT ASSEMBLY RH (RH POSITION)

  1. B107528
    Move the front seat assembly fully forward.

  1. Remove the 2 bolts on the rear side of the seat.

  1. Move the front seat assembly to the rearmost position.

  1. Remove the 2 bolts on the front side of the seat.

  1. Move the front seat assembly to the center of the seat slide rail. Set the seatback in the upright position.

  1. Disconnect the front seat inner belt assembly connector.

  1. Remove the front seat assembly.


2. REMOVE FRONT DOOR SCUFF PLATE RH (for RH Side)

3. REMOVE ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY (for RH Side)
  1. Roll up the carpet and remove the engine service hole sub cover.


4. REMOVE FRONT WHEEL

5. REMOVE FRONT SPEED SENSOR

  1. C320920
    for LH Side:

    1. Detach the 2 wire harness clamps from the body.

    2. Disconnect the connector.

  1. C318461
    for RH side:

    1. Disconnect the connector.

    2. Remove the bolt and bracket from the body.

  1. C320498
    Remove the bolt and disconnect the bracket from the upper arm.

  1. C321552
    Remove the bolt and disconnect the bracket from the steering knuckle.

  1. Remove the bolt and front speed sensor from the steering knuckle.

← REMOVAL (Oct 2014 – Dec 2014)INSPECTION (from Oct 2014) →