2014-2019 Hiace · Service Manual HEATER & AIR CONDITIONING SYSTEM

REMOVAL

Removal / installation · Vehicles built from Oct 2014


1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. Turn the A/C switch on.

  1. Operate the cooler compressor at an engine rpm of approximately 1,000 for 5 to 6 minutes to circulate the refrigerant and collect compressor oil remaining in each component into the cooler compressor as much as possible.

  1. Stop the engine.

  1. Using SST, let the refrigerant gas out.

    SST
    07110-58060   (07117-58080, 07117-58090, 07117-78050, 07117-88060, 07117-88070, 07117-88080)


2. REMOVE FRONT DOOR SCUFF PLATE RH

3. REMOVE FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type)

  1. B107528
    Move the front seat assembly fully forward.

  1. Remove the 2 bolts on the rear side of the seat.

  1. Move the front seat assembly to the rearmost position.

  1. Remove the 2 bolts on the front side of the seat.

  1. Move the front seat assembly to the center of the seat slide rail. Set the seatback in the upright position.

  1. Disconnect the front seat inner belt assembly connector.

  1. Remove the front seat assembly.


4. REMOVE FRONT SEAT ASSEMBLY RH (for Low-back Seat Type)

  1. B107542
    Move the front seat assembly fully forward.

  1. Remove the 2 bolts on the rear side of the seat.

  1. Move the front seat assembly to the rearmost position.

  1. Remove the 2 bolts on the front side of the seat.

  1. Move the front seat assembly to the center of the seat slide rail. Set the seatback in the upright position.

  1. Disconnect the front seat inner belt assembly connector.

  1. Remove the front seat assembly.


5. REMOVE ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY
  1. Roll up the carpet, and remove the engine service hole sub cover assembly.


6. REMOVE NO. 1 ENGINE UNDER COVER (w/ Engine Under Cover Assembly)

7. REMOVE FAN & GENERATOR V BELT (for 1KD-FTV)

  1. A156649E01
    Remove the drive belt by rotating the tensioner pulley clockwise to loosen its tension with the pulley set bolt of the tensioner.


8. REMOVE FAN & GENERATOR V BELT (for 2KD-FTV)

  1. A102808E03
    Remove the drive belt by rotating the tensioner pulley in clockwise direction to loosen its tension with the pulley set bolt of the tensioner.


9. REMOVE COOLER REFRIGERANT NO. 1 DISCHARGE HOSE

  1. E104243
    Remove the bolt and disconnect the cooler refrigerant discharge hose from the compressor and magnetic clutch.

  1. Remove the O-ring from the cooler refrigerant discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.


10. REMOVE COOLER REFRIGERANT NO. 1 SUCTION HOSE

  1. E104244
    Remove the bolt and disconnect the cooler refrigerant suction hose.

  1. Remove the O-ring from the cooler refrigerant suction hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.


11. REMOVE COMPRESSOR AND MAGNETIC CLUTCH
  1. Disconnect the connector.

  1. E104245
    Remove the 4 bolts and compressor and magnetic clutch.

← ON-VEHICLE INSPECTION (from Oct 2014)DISASSEMBLY (from Oct 2014) →