2014-2019 Hiace · Service Manual SUSPENSION & AXLE

REMOVAL

Removal / installation · Vehicles built from Oct 2014


1. REMOVE FRONT WHEEL

2. REMOVE FENDER APRON MUDGUARD SEAL

  1. C101965E01
    Remove the 4 clips and fender apron mudguard seal.


3. REMOVE TORSION BAR SPRING

  1. C101959E01
    Slide the dust cover on the anchor arm side and put matchmarks on the torsion bar spring, anchor arm, and front suspension torque arm.

  1. Hold the anchor arm adjust nut and remove the anchor arm lock nut with a wrench (22 x 24 mm).

  1. C101960E01
    Measure dimension A (to be used as a reference dimension in later steps) of the anchor arm adjusting hexagon bolt and note down the length.

  1. Loosen the anchor arm adjust nut to free the torsion bar spring.

  1. C103229E02
    Remove the following parts from the anchor arm.

    1. Anchor arm adjust nut. (Part A)

    2. Anchor arm adjust seat. (Part B)

    3. Anchor arm adjusting hexagon bolt. (Part C)

    4. Anchor arm swivel. (Part D)

  1. Remove the anchor arm and torsion bar spring.

  1. Remove the torsion bar dust cover from the torsion bar spring.


4. REMOVE FRONT SUSPENSION TORQUE ARM

  1. C101961E01
    Remove the 2 bolts and torque arm from the front suspension upper arm.

← COMPONENTS (from Oct 2014)INSPECTION (from Oct 2014) →