2014-2019 Hiace · Service Manual BODY

DISASSEMBLY

Removal / installation · Vehicles built from Oct 2014

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.
  3. Use the same procedure for the RH and LH sides.
  4. The procedure listed below is for the LH side.


1. REMOVE OUTER MIRROR LH (w/ Retract Mirror)

  1. B367136E01
    Push in the upper part of the mirror to tilt the mirror surface.

  1. Put protective tape on the outer rear view mirror assembly LH.

  1. Using moulding remover D, detach the 2 claws.

    Text in Illustration 
    *1
    Protective Tape
    *2
    Moulding Remover D

  1. Pull in the direction indicated by the arrow, detach the 2 guides and remove the outer mirror LH.


2. REMOVE OUTER MIRROR RETRACTOR LH (w/ Retract Mirror)

  1. Remove the clamp.

    1. B269432E01
      Remove the tape and clamp from the wire harness sub-assembly.
      Text in Illustration 
      *1
      Tape
      *2
      Clamp

  1. Remove the base sub-assembly.

    1. B276013E01
      Remove the tape.
      Text in Illustration 
      *1
      Tape

    2. B276038E01
      Cut the wire harness sub-assembly at the location shown in the illustration.
      Text in Illustration 
      *a
      Cut here

      HINT:
      A new wire harness sub-assembly is used for reassembly.

    3. B276039
      Detach the 5 claws and remove the gasket.

    4. B276040
      Using a T25 "TORX" socket wrench, remove the 3 "TORX" screws and base sub-assembly.

  1. B276041
    Using a T25 "TORX" socket wrench, remove the "TORX" screw and base plate.

  1. B276042
    Remove the 4 screws and body sub-assembly.

  1. B367343E01
    Remove the actuator sub-assembly.

    1. Detach the clamp.

    2. Move the rubber cover to disconnect the connector.

      Text in Illustration 
      *1
      Rubber Cover

    3. Pull out the wire harness sub-assembly as shown in the illustration.

    4. B276044
      Remove the 3 screws and actuator sub-assembly.

    5. B367339E01
      Using a screwdriver, detach the 2 claws and disconnect the 2 connectors.

      HINT:
      Tape the screwdriver tip before use.

      Text in Illustration 
      *1
      Protective Tape

← REMOVAL (from Jan 2017)INSPECTION (from Oct 2014) →