REMOVAL
Removal / installation · Vehicles built from Jan 2017
Versions by build date: Oct 2014 – Dec 2016 from Jan 2017
| 1.
REMOVE REAR WIPER ARM AND BLADE ASSEMBLY
|
 |
- Disengage the 3 claws and separate the head cap as shown in the illustration.
Remove the rear wiper arm nut and rear wiper arm and blade assembly.
| 2.
REMOVE REAR WIPER SHAFT COVER
|
 |
- Remove the rear wiper shaft cover.
| 3.
REMOVE REAR NO. 1 WIPER LINK PIVOT WASHER
|
 |
- Using the socket wrench (27 mm), remove the lock nut and rear No.1 wiper link pivot washer.
- NOTICE:
- Do not damage the glass.
| 4.
REMOVE BACK DOOR TRIM BOARD ASSEMBLY UPPER |
 |
w/o Rear Wiper:
(Click here)
w/ Rear Wiper:
(Click here
for Wide Body:
(Click here)
| 5.
REMOVE REAR WIPER MOTOR ASSEMBLY
|
 |
- Disconnect the connector and remove the clamp.
Remove the 3 bolts and rear wiper motor and grommet as a unit.
- Remove the grommet from the rear wiper motor.
| 6.
REMOVE EMERGENCY HAMMER CAUTION PLATE (w/ Emergency Hammer Caution Plate) |
 |
- HINT:
- If a emergency hammer caution plate is damaged, replace it with a new one.
Remove the emergency hammer caution plate.
| 7.
REMOVE BACK DOOR GLASS |
 |
- Apply protective tape to the outer surface of the vehicle body to prevent scratches.
Text in Illustration
*1
|
Protective Tape
|
- From the interior, insert piano wires between the vehicle body and back door glass as shown in the illustration.
Tie objects that can serve as handles (for example, wooden blocks) to all wire ends.
- NOTICE:
- When separating the back door glass from the vehicle, be careful not to damage the vehicles paint or interior/exterior ornaments.
Cut through the adhesive by pulling the piano wire around the back door glass.
Using a suction cup, remove the back door glass.
- NOTICE:
- Leave as much adhesive on the vehicle body as possible when removing the back door glass.