2014-2019 Hiace · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built from Oct 2014


1. INSTALL FRONT WIPER MOTOR

  1. E108765
    Using a "torx" socket wrench (T30), install the front wiper motor with the 2 bolts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

  1. E061919
    Apply MP grease to the crank arm pivot of the front wiper motor.

  1. Install the rod to the front wiper motor as shown in the illustration.


2. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

  1. E108766
    Engage the grommet as shown in the illustration.

  1. Install the windshield wiper motor and link assembly with the 2 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Connect the connector.


3. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

  1. E108767E01
    Body type narrow:

    1. Install the cowl top ventilator louver sub-assembly with the 10 claws and 6 clips.

  1. Body type wide:

    1. Install the cowl top ventilator louver sub-assembly with the 11 claws and 7clips.

  1. Connect the washer hose.


4. INSTALL COWL VENT COVER LH

5. INSTALL COWL VENT COVER RH

6. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH

  1. B108016E03
    Operate the wiper, and stop the windshield wiper motor assembly at the automatic stop position.

  1. Clean the wiper arm serrations.

  1. Clean the wiper pivot serrations with a wire brush (when reinstalling).

  1. E108758E01
    Install the front wiper arm and blade assembly LH with the nut at the position as shown in the illustration.

    Torque:
    25 N*m{ 225 kgf*cm , 18 ft.*lbf }

    HINT:
    Hold the arm hinge by hand to fasten the nut.


7. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH

  1. B108016E03
    Clean the wiper arm serrations.

  1. Clean the wiper pivot serrations with a wire brush (when reinstalling).

  1. E108757E01
    Install the front wiper arm and blade assembly RH with the nut at the position as shown in the illustration.

    Torque:
    25 N*m{ 225 kgf*cm , 18 ft.*lbf }

    HINT:
    Hold the arm hinge by hand to fasten the nut.


8. INSTALL WINDSHIELD WIPER ARM COVER
  1. Install the 2 windshield wiper arm covers.

  1. Operate the front wipers while spraying water or washer fluid on the windshield. Make sure that the wipers function properly and there is no interference with the vehicle body.

← INSPECTION (from Oct 2014)COMPONENTS (from Oct 2014) →