Attach the 6 clips to install the upper back door trim board assembly.
3.
INSTALL REAR NO.1 WIPER LINK PIVOT WASHER
Install the rear No.1 wiper link pivot washer from the outside of the vehicle with the installation mark at the top.
Using the socket wrench (27 mm), install the lock nut.
Torque:
12 N*m{
120 kgf*cm
, 9 ft.*lbf
}
NOTICE:
Do not damage the glass.
4.
INSTALL REAR WIPER SHAFT COVER
5.
INSTALL REAR WIPER ARM AND BLADE ASSEMBLY
Operate the wiper, and stop the rear wiper motor at the automatic stop position.
Clean the wiper arm serrations.
Clean the wiper pivot serrations with a wire brush (when reinstalling).
Install the rear wiper arm and blade assembly with the nut at the position as shown in the illustration.
Torque:
9.8 N*m{
100 kgf*cm
, 87 in.*lbf
}
HINT:
Hold the arm hinge by hand to fasten the nut.
Operate the rear wiper while spraying water or washer fluid on the windshield. Make sure that the wipers function properly and there is no interference with the vehicle body.