2014-2019 Hiace · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built Dec 2015 – Dec 2016

Versions by build date: Oct 2014 – Nov 2015 Dec 2015 – Dec 2016 from Jan 2017


1. INSTALL REAR WIPER MOTOR

  1. E104706E01
    Install the grommet as shown in the illustration.

  1. E103138E01
    Install the rear wiper motor with the 3 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Install the clamp and connect the connector.


2. INSTALL BACK DOOR TRIM BOARD ASSEMBLY UPPER

  1. B101147E01
    Attach the 6 clips to install the upper back door trim board assembly.


3. INSTALL BACK WINDOW GLASS HAMMER ASSEMBLY (w/ Hammer)
(Click here)

4. INSTALL REAR NO.1 WIPER LINK PIVOT WASHER

  1. E103141E02
    Install the rear No.1 wiper link pivot washer from the outside of the vehicle with the installation mark at the top.

  1. E103140
    Using the socket wrench (27 mm), install the lock nut.

    Torque:
    12 N*m{ 120 kgf*cm , 9 ft.*lbf }

    NOTICE:
    Do not damage the glass.


5. INSTALL REAR WIPER SHAFT COVER

6. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY

  1. B108016E03
    Operate the wiper, and stop the rear wiper motor at the automatic stop position.

  1. Clean the wiper arm serrations.

  1. Clean the wiper pivot serrations with a wire brush (when reinstalling).

  1. E103534E01
    Install the rear wiper arm and blade assembly with the nut at the position as shown in the illustration.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }

    HINT:
    Hold the arm hinge by hand to fasten the nut.

  1. Operate the rear wiper while spraying water or washer fluid on the windshield. Make sure that the wipers function properly and there is no interference with the vehicle body.

← INSTALLATION (Oct 2014 – Nov 2015)INSTALLATION (from Jan 2017) →