INSTALLATION
Removal / installation · Vehicles built from Oct 2014
| 1. INSTALL FRONT SEATBACK CENTER ASSEMBLY |
Install the front seatback center assembly with the 4 bolts.

- Torque:
- 39 N*m{ 398 kgf*cm , 29 ft.*lbf }
- NOTICE:
- Tighten the bolts in the following order:
- Temporarily tighten bolt (1).
- Fully tighten bolt (2).
- Fully tighten bolt (1).
- Fully tighten bolt (3).
- Fully tighten bolt (4).
- Tighten the bolts in the following order:
| 2. INSTALL FRONT SEATBACK ASSEMBLY |
Install the front seatback assembly with the 4 bolts.

- Torque:
- 39 N*m{ 398 kgf*cm , 29 ft.*lbf }
- NOTICE:
- Tighten the bolts in the order indicated in the illustration.
| 3. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD |
w/o Seat belt warning occupant detection sensor:

Install the separate type front seat cushion cover with pad with the 2 bolts.
- Torque:
- 39 N*m{ 398 kgf*cm , 29 ft.*lbf }
- NOTICE:
- Make sure that the wire frame of the separate type front seat cushion cover is completely engaged.
- Tighten the bolts in the following order.
- Temporarily tighten bolt (2).
- Fully tighten bolt (1).
- Fully tighten bolt (2).
- Make sure that the wire frame of the separate type front seat cushion cover is completely engaged.
w/ Seat belt warning occupant detection sensor:

Connect the connector.
Install the separate type front seat cushion cover with pad with the 2 bolts.
- Torque:
- 39 N*m{ 398 kgf*cm , 29 ft.*lbf }
- NOTICE:
- Make sure that the wire frame of the separate type front seat cushion cover is completely engaged.
- Tighten the bolts in the following order.
- Temporarily tighten bolt (2).
- Fully tighten bolt (1).
- Fully tighten bolt (2).
- Make sure that the wire frame of the separate type front seat cushion cover is completely engaged.
