DIAGNOSIS SYSTEM
Troubleshooting · Vehicles built from Jan 2015
| J-OBD2 |
OBD regulations require that the vehicle's on-board computer illuminates the MIL on the instrument panel when the computer detects a malfunction in:
![]() ![]() |
The emission control system/components.
The powertrain control components (which affect vehicle emissions).
The computer
In addition, the applicable DTCs are recorded in the ECM memory. If the malfunction does not recur in 3 consecutive trips, the MIL turns off automatically but the DTCs remain recorded in the ECM memory.
| NORMAL MODE AND CHECK MODE |
| 2 TRIP DETECTION LOGIC |
| FREEZE FRAME DATA |
| DLC3 (Data Link Connector 3) |
| INSPECT BATTERY VOLTAGE |
- Battery Voltage:
- 11 to 14 V
| CHECK MIL |
Check that the MIL illuminates when turning the ignition switch to ON.
If the MIL does not illuminate, there is a problem in the MIL circuit (Click here).When the engine is started, the MIL should go off.
| ALL READINESS |
- HINT:
- With "All Readiness" you can check whether or not the DTC judgment has been completed by using the GTS.
- You should check "All Readiness" after duplicating malfunction symptoms or for validation after finishing repairs.
- With "All Readiness" you can check whether or not the DTC judgment has been completed by using the GTS.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Clear the DTCs (Click here).
Turn the ignition switch off.
Turn the ignition switch to ON and turn the GTS on.
Perform the DTC judgment driving pattern to run the DTC judgment.
Enter the following menus: Powertrain / Engine and ECT / Utility / All Readiness.
Input the DTCs to be confirmed.
Check the DTC judgment result.
GTS Display
Description
NORMAL
- DTC judgment completed
- System normal
ABNORMAL
- DTC judgment completed
- System abnormal
INCOMPLETE
- DTC judgment not completed
- You should perform driving pattern after confirming DTC enabling conditions
N/A
- Unable to perform DTC judgment
- Number of DTCs which do not fulfill DTC preconditions has reached ECU's memory limit
- DTC judgment completed

