2014-2019 Hiace · Service Manual ENGINE

FAIL-SAFE CHART

System information · Vehicles built from Oct 2014

If any of the following DTCs are stored, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily.
DTC
Component
Fail-Safe Operation
Fail-Safe Deactivation Condition
P00B3 and P00B4
Engine Coolant Temperature (Radiator) Sensor
The ECM operates the cooling fan at a fixed voltage.
Pass condition detected
P0102 and P0103
Mass Air Flow Meter
The ECM calculates the ignition timing according to the engine speed and throttle valve position.
Pass condition detected
P0110, P0112 and P0113
Intake Air Temperature Sensor
The ECM estimates the intake air temperature to be 20°C (68°F).
Pass condition detected
P0115, P0117 and P0118
Engine Coolant Temperature Sensor
The ECM estimates the engine coolant temperature to be 80°C (176°F).
Pass condition detected
P0120, P0121, P0122, P0123, P0220, P0222, P0223, P0604, P0606, P0607, P0657, P2102, P2103, P2111, P2112, P2118, P2119 and P2135
Electronic Throttle Control System
The ECM cuts off the throttle actuator current and the throttle valve returns to a throttle position of 6.5° by the return spring.
The ECM then adjusts the engine output by controlling the fuel injection (intermittent fuel-cut) and ignition timing in accordance with the accelerator pedal opening angle to allow the vehicle to continue at a minimal speed.*1
Pass condition detected and then ignition switch turned off
P0327 and P0328
Knock Sensor
The ECM sets the ignition timing to maximum retard.
Ignition switch off
P0351 to P0354
Igniter
The ECM cuts the fuel.
Pass condition detected
P0504
Stop Light Switch
The accelerator pedal opening angle is fixed when there is an accelerator pedal malfunction or history of a malfunction.
Pass condition detected
P2120, P2121, P2122, P2123, P2125, P2127, P2128 and P2138
Accelerator Pedal Sensor
The accelerator pedal sensor has 2 sensor circuits: Main and Sub.
If either of the circuits malfunctions, the ECM controls the engine using the other circuit.
If both of the circuits malfunction, the ECM regards the accelerator pedal as being released. As a result, the throttle valve is closed and the engine idles.
Pass condition detected and then ignition switch turned off

HINT:
*1: The vehicle can be driven slowly when the accelerator pedal is depressed firmly and slowly. If the accelerator pedal is depressed quickly, the vehicle may speed up and slow down erratically.

← CHECK MODE PROCEDURE (from Oct 2014)DATA LIST / ACTIVE TEST (from Oct 2014) →