2014-2019 Hiace · Service Manual ENGINE

P1670 Injection Pump Control Module ROM Test Error

Diagnostic trouble codes · Vehicles built Oct 2014 – Dec 2014

Versions by build date: Oct 2014 – Dec 2014 from Jan 2015

DESCRIPTION

To compensate for the change in injection volume and injection timing caused by the variance in the injection or supply pump assembly itself, a correction is made by using the data that is stored in the ROM in the injection pump correction unit.
DTC No.
DTC Detection Condition
Trouble Area
P1670
When the ignition switch was turned ON, or when the ECM determines whether it is an error of RAM in ECM or not, the ECM conducts a single communication. If any one of the following status occurs in the communication, the ECM conducts one more communication. While the ECM is conducting the communication, if (a) is duplicated 20 times continuously, or if (b) is duplicated 20 times continuously, or if (c) is duplicated 2 times continuously, the ECM outputs the DTC P1670.
(a) There was a communication error when receiving data.
(b) Data sent from the injection pump correction unit does not match to the data received from the ECM.
(c) Data received from the pump ROM is not input in the period of 1024 msecond.
Although the determining process is completed without a problem, the ECM conducts the communication again if an undefined code is found while checking an identification code of the receiving data. If the undefined code was duplicated 20 times in a row, the ECM outputs the DTC.
  1. Open or short in injection or supply pump assembly correction unit circuit
  2. Injection pump correction unit (Injection or supply pump assembly)
  3. ECM

WIRING DIAGRAM

A311407E04

INSPECTION PROCEDURE

HINT:
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


1. CHECK HARNESS AND CONNECTOR (ECM - INJECTION PUMP CORRECTION UNIT)
  1. Disconnect the injection pump correction unit connector.

  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D60-1 (DATA) - D100-118 (DATA)
    Always
    Below 1 Ω
    D60-4 (CLK) - D100-119 (CLK)
    Always
    Below 1 Ω
    D60-1 (DATA) or D100-118 (DATA) - Body ground
    Always
    10 kΩ or higher
    D60-4 (CLK) or D100-119 (CLK) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. REPLACE INJECTION OR SUPPLY PUMP ASSEMBLY
  1. Replace the injection or supply pump assembly (Click here).


NEXT


3. READ OUTPUT DTC (DTC P1670 IS OUTPUT AGAIN)
  1. Clear the DTC (Click here).

  1. Turn the ignition switch to ON.

  1. Check the DTC (Click here).

    Result:
    Display (DTC output)
    Proceed to
    DTC P1670 is output again
    A
    No DTC output
    B



B
SYSTEM OK
A

REPLACE ECM (Click here)


← P1611 ECM/PCM Processor / Run Pulse (from Jan 2015)P1670 Injection Pump Control Module ROM Test Error (from Jan 2015) →