2014-2019 Hiace · Service Manual SECURITIES

Security Indicator Light Does not Blink

Circuit diagnosis · Vehicles built from Apr 2016

Versions by build date: Oct 2014 – Mar 2016 from Apr 2016

DESCRIPTION

  1. The certification ECU (smart key ECU assembly) blinks the security indicator light when the immobiliser is set (engine switch off, or driver door is opened and closed with engine switch on (IG)).

WIRING DIAGRAM

E271706E03

INSPECTION PROCEDURE

NOTICE:
  1. When using the GTS with the engine switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry & Start (CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.
  2. Before replacing the certification ECU (smart key ECU assembly), refer to Service Bulletin.


1. PERFORM ACTIVE TEST USING GTS (SECURITY INDICATOR LIGHT)
  1. Connect the GTS to the DLC3.

  1. Turn the engine switch on (IG).

  1. Turn the GTS on.

  1. Enter the following menus: Body Electrical / Entry & Start / Active Test.

  1. Perform the Active Test according to the display on the GTS.

    Entry & Start (Certification ECU [Smart Key ECU Assembly]) 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Immobiliser Indicator
    Security indicator light
    OFF/ON
    -

    OK:
    The security indicator light operates normally.



NG
Go to step 2
OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)

2. CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - CERTIFICATION ECU [SMART KEY ECU ASSEMBLY] AND BODY GROUND)
  1. Disconnect the B75 certification ECU (smart key ECU assembly) connector.

  1. Disconnect the H20 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H20-29 (LP) - B75-15 (IND)
    Always
    Below 1 Ω
    H20-29 (LP) - Body ground
    Always
    10 kΩ or higher
    B75-15 (IND) - Body ground
    Always
    10 kΩ or higher
    H20-21 (E1) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
  1. Connect the B75 certification ECU (smart key ECU assembly) connector.

  1. Check for pulses according to the value(s) in the table below.

    Standard:
    Tester Connection
    Condition
    Specified Condition
    H20-29 (LP) - Body ground
    Engine switch off → on (IG)
    Pulse generation → Below 2 V



NG
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)


← Security Indicator Light Does not Blink (Oct 2014 – Mar 2016)Immobiliser System does not Operate Properly (Oct 2014 – Dec 2014) →