Security Indicator Light Does not Blink
Circuit diagnosis · Vehicles built Oct 2014 – Mar 2016
Versions by build date: Oct 2014 – Mar 2016 from Apr 2016
DESCRIPTION
- The certification ECU (smart key ECU assembly) blinks the security indicator light when the immobiliser is set (engine switch off, or driver door is opened and closed with engine switch on (IG)).
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When using the GTS with the engine switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry & Start (CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.
- Before replacing the certification ECU (smart key ECU assembly), refer to Service Bulletin.
- When using the GTS with the engine switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry & Start (CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.
| 1. PERFORM ACTIVE TEST USING GTS (SECURITY INDICATOR LIGHT) |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Entry & Start / Active Test.
Perform the Active Test according to the display on the GTS.
Entry & Start (Certification ECU [Smart Key ECU Assembly]) Tester Display
Test Part
Control Range
Diagnostic Note
Immobiliser Indicator
Security indicator light
OFF/ON
-
- OK:
- The security indicator light operates normally.
|
|
||||
| OK | ||
| ||
| 2. CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - CERTIFICATION ECU [SMART KEY ECU ASSEMBLY] AND BODY GROUND) |
Disconnect the B75 certification ECU (smart key ECU assembly) connector.
Disconnect the H20 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
H20-29 (LP) - B75-15 (IND)
Always
Below 1 Ω
H20-29 (LP) - Body ground
Always
10 kΩ or higher
B75-15 (IND) - Body ground
Always
10 kΩ or higher
H20-21 (E1) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | |
| 3. CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) |
Connect the B75 certification ECU (smart key ECU assembly) connector.
Check for pulses according to the value(s) in the table below.
- Standard:
Tester Connection
Condition
Specified Condition
H20-29 (LP) - Body ground
Engine switch off → on (IG)
Pulse generation → Below 2 V
|
|
||||
| OK | ||
| ||
