HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Jan 2017
Versions by build date: Jan 2015 – Nov 2015 Dec 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017
- HINT:
- The ECM of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN and multiplex communication system.
- *: Use the GTS.
- The ECM of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN and multiplex communication system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
Refer to the How to Troubleshoot ECU Controlled Systems in Introduction section (Click here).
| |||||
| 3.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
| |||||
| 4.CONNECT GTS TO DLC3* |
| |||||
| 5.CHECK AND CLEAR DTCS AND FREEZE FRAME DATA* |
Refer to DTC Check/Clear (Click here).
| |||||
| 6.VISUAL INSPECTION |
| |||||
| 7.SELECT CHECK MODE DIAGNOSIS* |
Refer to Check Mode Procedure (Click here).
| |||||
| 8.PROBLEM SYMPTOM CONFIRMATION |
Refer to Road Test (Click here).
Result Result
Proceed to
Symptom does not occur
A
Symptom occurs
B
|
|||||
| |||||
| 9.SYMPTOM SIMULATION |
Refer to Symptom Simulation (Click here).
| |||||
| 10.DTC CHECK* |
Refer to DTC Check/Clear (Click here).
Result Result
Proceed to
DTC is not output
A
DTC is output
B
|
|||||
| |||||
| 11.BASIC INSPECTION |
Refer to Park/Neutral Position Switch Assembly (Click here).
Refer to Shift Lever Assembly (Click here).
|
|||||
| |||||
| 12.MECHANICAL SYSTEM TESTS |
Refer to Mechanical System Tests (Click here).
|
|||||
| |||||
| 13.HYDRAULIC TEST |
Refer to Hydraulic Test (Click here).
|
|||||
| |||||
| 14.MANUAL SHIFTING TEST |
Refer to Manual Shifting Test (Click here).
|
|||||
| |||||
| 15.PROBLEM SYMPTOMS TABLE CHAPTER 1 |
Refer to Problem Symptoms Table (Click here).
|
|||||
| |||||
| 16.PROBLEM SYMPTOMS TABLE CHAPTER 2 |
Refer to Problem Symptoms Table (Click here).
| |||||
| 17.COMPONENT INSPECTION |
|
| 18.DTC CHART |
Refer to Diagnostic Trouble Code Chart (Click here).
| |||||
| 19.CIRCUIT INSPECTION |
| |||||
| 20.IDENTIFICATION OF PROBLEM |
| |||||
| 21.REPAIR OR REPLACE |
| |||||
| 22.CONFIRMATION TEST |
| |||||