2014-2019 Hiace · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built Apr 2016 – Dec 2016

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017


1. INSTALL CHARCOAL CANISTER ASSEMBLY
  1. Install the charcoal canister assembly to the bracket.

  1. Connect the 2 purge line hoses, and slide the 2 clamps to secure the hoses.


2. INSTALL BATTERY CARRIER
  1. Install the battery carrier with the 3 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Attach the wire harness clamp to the battery carrier.

  1. Connect the battery thermometer sensor connector.


3. INSTALL BATTERY

4. INSTALL BATTERY CLAMP SUB-ASSEMBLY
  1. Temporarily install the bolt and tighten the nut.

  1. Adjust the battery clamp sub-assembly position.

  1. Tighten the bolt and nut.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


5. CONNECT CABLE TO POSITIVE BATTERY TERMINAL
  1. Connect the positive (+) battery terminal to the battery and tighten the nut.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
  1. Connect the negative (-) battery terminal to the battery and tighten the nut.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

    NOTICE:
    When disconnecting the cable some systems need to be initialized after the cable is reconnected (Click here).


7. PERFORM INITIALIZATION
(Click here)
← INSTALLATION (Jan 2015 – Mar 2016)INSTALLATION (from Jan 2017) →